To answer this question the voltage of the generator must be given.
To answer this question the voltage of the generator must be given. That is because for each phase the kVA figure is equal to the line-neutral kV times the amps.
106 amps
If your generator is rated at 1000 watts continuous......and you are using 120V.....available amps are 1000/120 =8.3 .
At 240v single phase it's 70.8 amps. If it runs on 2 wires plus ground, take the voltage rating of the equipment and divide that into the watts to get amps. At 480v 3 phase it's 25.8 amps. At 208v 3 phase it's 47.2 amps. <<>> There are zero amps in 14 kW. A voltage needs to be stated. I = W/E, Amps = Watts/Volts.
There is not enough information provided to answer. KVA is short for "Kilo Volt Amperes". That is, thousands of Volt Amps. In order to determine how many Amperes are flowing, you must know at what voltage it is operating. Amperes = 45,000 ÷ volts Bill Slugg
36.6 amps maximum at 120 volts, but should not be loaded to over 29 amps. At 240 volts it will produce a maximum of 18.3 amps but never loaded to any more than 14.6 amps.
62.5 amps
75 Amps theoretically Need to know if the generator is 3 phase or single phase.
The formula you are looking for is , A = kva x 1000/Volts.
Typically 75 amps on natural gas, 85 amps using propane. Peak amps(for less than a second) to start a big appliance, like an A/C condenser, are 130.
It depends upon the Generator system voltage. For 3 Phase, 600 Volt system, it will be 73 Amps For 3 Phase, 480 Volt system, it will be 90 Amps For 3 Phase, 208 Volt system, it will be 208 Amps
It means 225 amps on each phase.
50 Amps Single Phase 20 Amps Three Phase
The equation that you are looking for is I = W/E. Amps = Watts/Volts. The generator has the capacity to supply 25 amps. Of course the load is what governs the amount of amperage drawn. Any load greater than 25 amps will load the generator down and probably trip the generator's breaker.
A generator does not use amps it generates amperage. To answer this question the generators voltage must be stated.
5.5kva
You will need a 50 kW generator for a single phase 120/240 volt service.
106 amps