4.68
32cm (8 sides x 4cm = 32cm)
This will depend on how long you would like each piece to be. If each piece is to be 1 inch long, then 115 pieces could be cut. If each piece is 2 inches long, then 57 pieces with 0.5 inches left over If each pieces is 5 inches long, then 23 pieces and so on and so forth.
1 metre = 100 cm 2.5 metres = (2.5 times 100) = 250 cm If each piece is 10 cm, there can be (250 divided by 10) pieces = 25 pieces, provided no ribbon is wasted in the process of cutting.
Each of the 36 pieces is one quarter of one of the original ribbons. Therefore there are 36 quarter pieces of ribbon. Thus there were originally 36 × 1/4 = 9 ribbons
You can cut off as many pieces as you want. Once you decide that, you'll be able to figure out how long each piece should be.
DiscountDancewear.com
32cm (8 sides x 4cm = 32cm)
6 pieces can be made, assuming you lose nothing in the cutting. 9/1.5 = 6.
If 104 yards of ribbon is cut into 14 equal length pieces, each piece will have length of 7.43 yards, to the justified number of significant digits.
200
This will depend on how long you would like each piece to be. If each piece is to be 1 inch long, then 115 pieces could be cut. If each piece is 2 inches long, then 57 pieces with 0.5 inches left over If each pieces is 5 inches long, then 23 pieces and so on and so forth.
1 metre = 100 cm 2.5 metres = (2.5 times 100) = 250 cm If each piece is 10 cm, there can be (250 divided by 10) pieces = 25 pieces, provided no ribbon is wasted in the process of cutting.
30m/2.6dm = 30m/0.26m = 115.3.. ie 115 pieces.
Cut two pieces of trimmer line about 6-8 ft long. Push the line into the opening in the spool until it comes out of the bottom of the spool. Place the end of the line into the small hole adjacent to the opening where the line came out of the spool. Pull the line tight while holding your finger on the line in the hole. Do this for both sides and then wind the spool in the reverse direction to fill the spool. Pull on the line occasionally to make sure the line is not binding up in the spool. There are spools that will take one single long line, where the center of the line is attached to a notch (or similar) in the center of the spool and then wound with one line on each side of the spool. Then, the end of each line is threaded through each hole in the trimmer head. It would be best if you consulted a user's manual. Try the following website for a downloadable manual for your application: managemylife.com or manualsonline,com
Step 1: Lift the top off the typewriter. Step 2: Remove the old ribbon. On a manual, lift the spools out directly. For a cartridge, press the release lever. Step 3: Set aside. Step 4: Place the new cartridge in the holder and snap down. Step 5: For a spool model, place the two spools in the holders. Step 6: Thread the ribbon through the wire holding it in front of the roller. Step 7: Close the top.
Each of the 36 pieces is one quarter of one of the original ribbons. Therefore there are 36 quarter pieces of ribbon. Thus there were originally 36 × 1/4 = 9 ribbons
You can cut off as many pieces as you want. Once you decide that, you'll be able to figure out how long each piece should be.