Want this question answered?
A scale ie required to measure the area of a circle. We need to measure the radius of that Circle and then we can put this radius valve in below mwntioned formula & can calculate the area. A=3.14*r*r where r is radius in Cm. A is are in cm square. Hemant gautam +919099921329
data sheet of control valve
the egr valve is underneath the air filter housing. WARNING: there are multiple things to cause the EGR system to malfunction other than the valve (BPT valve, broken vaccum hose, solenoid, clogged ports, EGR temp sensor). A good diagnosis would be worth being wrong by just replacing the valve. Trust me, I used to work for a Nissan dealer
Code P1491 Means: EGR Valve Lift Insufficient Detected EGR Valve needs to be replaced
he discovered a artificial heart valve
http://wiki.answers.com/Q/How_many_sprinklers_can_you_run_on_one_valve_if_your_sprinkers_have_a_fifteen_ft_spray_radius"
No, sprinklers in a deluge system are "open"; no valve in the sprinkler, and an automatic valve turns on the water to all open sprinklers when a fire condition is detected.
High water pressure could be the reason for pipes to rattle when you turn on the outside sprinklers. You may need to have a reducer valve installed.
Yes, you can clean the PCV valve. Take off the PCV valve and get a spray can of carb cleaner. Just spray into the valve and just enough to clean out any gunk that might be in there. You should hear it rattle when you shake the valve.
Spray some carburetor cleaner onto the valve cover and inside the valve itself making sure not to spray onto or into any other parts of the valve housing. Clean away the loosened gunk with a rag and wire brush and continue until the valve moves smoothly.
Spray wd40 or equal and tap valve "gently" with a hammer while "gently" appling turn pressure on valve.
Some fire sprinkler systems have a valve for testing the water-flow alarm by allowing water to flow to the alarm, or through the alarm-sensing pipe, without activating any sprinklers in the rest of the system.
After unbolting the EGR valve, clean it with a carburetor spray. Allow it to dry completely before reinstalling the valve.
Deluge valves are hydraulically operated differential type valves used to control water supply to a deluge system. Deluge systems use open sprinklers or nozzles. Trim sets are used to control the operation of the valve.
Deluge valves are hydraulically operated differential type valves used to control water supply to a deluge system. Deluge systems use open sprinklers or nozzles. Trim sets are used to control the operation of the valve.
Start the engine, and spray a little carb cleaner around and on the EGR valve. If the engine changes sound are idles up are down then the valve is bad.
The can contains a fluid, and a propelling gas. When you push down on the valve, it opens. The pressurized gas inside pushes the fluid out through the valve and the spray nozzle.