assuming you mean 3/4" Thick.
30" X 108" / 144 sq"/sq ft = 22.5 X 32" / (3/4) = 960 square feet
Wane is the uncut edge of a board that has been milled from a tree. Essentially it is the 'bark' edge so instead of having a square cut piece of wood you have the contour of the outer edge of the tree on one or both sides of milled board. Once the board is 'edged' or squared off then you have dimesional lumber.
That is 32 board feet.
At one time, sawmills cut green lumber to 2"x8". A higher-humidity board would shrink more than an dryer board, and in any case, the board would be reduced in size by planing (smoothing the rough-cut sides.) Seems to me that the industry standardized the size of wood about 40 yeas ago. Now, sawmills calculate the size to cut so that dried and planed wood will be a standard size when dried. A 2x6 is actually 1.5 inches thick and 7.25 inches wide.
9
None. Board foot is a measure of volume not area.
The area of a square game board is 144 sq. in. What is the length of one of the sides of the board? Answer: 12 inches
8.25 square feet.
A board foot is one square foot by one inch thick or 4 quarters (4/4). If you were using something thicker, then the square footage provided would be proportionately less. I.e. 8/4 lumber would yield half the square footage but would be twice as thick (2"). So, using 4/4 lumber would mean 2000 board feet for the house assuming no waste.
Though "board foot" sounds a measurement of area it is actually a measurement of volume. 1 board foot equals 144 cubic inches of wood. Length x Width x Thickness = Board Feet Therefore a board that is 12 inches x 12 inches x 1 inch is 1 board foot. But so is a board that is 12 x 6 x 2 However, you must take into account the fact that all lumber is actually a different size than it says it is. A 2 x 12 is actually 1-1/2 by 11-1/2. So instead of a board foot of 1 x 12 being 12 inches long, it would be: 144 / (3/4 x 11-1/2) or 13.22 inches long.
It depends on how many inches. Area in square inches = width (in inches) x length (in inches)
19 5/8 inches
Measure the length plus the width, double that number. Take that number and multiply it by the height of the base board. That will give you the number of square inches of base. Divide the number of square inches by 144 and that will give you the square feet. There are 144 square inches in each square foot.
12
2,000 square inches
Usually, 2,400 square foot, single-family home requires about 16,000 board feet of framing lumber . Furthermore, over 14,000 square feet of other wood is also required.
Wane is the uncut edge of a board that has been milled from a tree. Essentially it is the 'bark' edge so instead of having a square cut piece of wood you have the contour of the outer edge of the tree on one or both sides of milled board. Once the board is 'edged' or squared off then you have dimesional lumber.
Cupping is when a board curves in the width of the board