In relation to the 10 cm pulley a 5 cm pulley has half the circumference thus will rotate on the same line or belt twice as often.
circumference = 2 x pi x radius or pi x diameter, when comparing 2 circumferences the value of pi is immaterial. Thus 10cm/5cm = 2
The word 'turn' appears 320 times in the King James version.
200 times
The word "turn" is in the King James Version of the Bible 283 times. It is in 271 verses.
cox
A pulley is just a wheel with a groove to hold a belt ,rope or chain. Your car likely has pulleys to run the radiator fan , the water pump , the air conditioner and the power steering. Elevators have a pulley. Your furnace probably has a pulley driven fan or pump. Movie projectors and video tape players have pulleys. Bicycles has a pulley to allow the pedal crank shaft to turn the drive wheel.
No, it's bolted to the end of the crank which pistons/rods attached to.
Alternators are driven by belts attached to one or more pulleys on the engine to turn the pulley on the alternator.
Yes you do.
Most bolts turn counterclockwise to come off. Year, make, model and which pulley would be helpful.
you need to get a wrench and turn the bolt (relieve the pressure on the pulley) on the tensioner pulley and remove the belt then turn bolt (relieve the pressure on the pulley) to reinstall it. The tensioner pulley is the one that is not your A/C pulley not your alternator pulley and not your crankshaft pulley its the only one that's left no hoses or plugs going to it. not sure how to explain it.
A simple enough question, but complicated by so many possible variations. For instance, place two cog wheels together so that their teeth mesh. Turn cog A clockwise and cog B will turn anticlockwise (counterclockwise in America). But if you replaced the toothed cogs with a pair of single pulley wheels with some distance apart. Pulling on the rope would turn the top pulley A clockwise and the pulley wheel B clockwise also. But, let us suppose that the rope has been deliberately twisted (not straightly laid) then the pulley B would be turning anticlockwise when the pullet A was turning clockwise.The rate of travel (RPM) would depends on the diametres of the pulley wheels - variations once more!
A steeringwheel can turn around 3 times
It is a wheel that allows for the vector (direction) of a force to be changed. So if I was pulling down on a pulley, the pulley could turn that into me pulling something up.
a pulley is a wheel with a grooved rim in which a rope, chain, or belt can run in order to change the direction or point of application of a force applied to the rope, etc. There is a pulley in a car the pulley turns the belt that goes around it to turn another pulley that might turn the water pump, or alt., or a/c. Hope this answers your question! :)
As many times as they want.
No, the alternator is the charging device which runs off a belted pulley attached to the motor. The alternator charges the battery which is the source of the current required to get the engine turning over and in turn starting the engine.
2 times