How to find the center of a screwed 45 degree elbow-?

Updated: 12/8/2022
User Avatar


Lvl 1
9y ago

Best Answer

You find the center of a screwed 45 degree elbow by bisecting the angle.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

9y ago

To find the center of a screwed 45 degree elbow simply bisect the angle.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to find the center of a screwed 45 degree elbow-?
Write your answer...
Still have questions?
magnify glass
Related questions

How find the 90 degree elbow center?

How to calculate 90 degree and 40 degree elbow center >For 90 degree elbow(Dia*38.1) this formula used for only 90 degree elbow. >For 45 degree elbow(45/2of tan*Dia*1.5*25.4) this answer obtained in (mm).

What is a formula to find center of an 90 degree elbow?

Measure 45o

How do you find elbow center?

1inch 90degree elbow centre

How do you find center of short radius elbow?

ow can i know the radius of short radius elbow 45 & 90

How do you find the degree of elbow?

get a compas and put it so it is 90 degrees to the LEFT make shure you can only jus se the right angle and there you have it thedegree of a caterpillar elbow

How do you find the radius of a PVC elbow?

just buy a PVC with a 90 degree already on it, then hook up a straight hose!

Find offsets with elbows on round ductwork?

adding an elbow is like adding another piece of duct,in other words you will gain length. you have to measure using centers. lets say that you have a duct that you want to make an offset to change your location or elevation,measure the distance from starting point to finish point either end to center or center to center,say your measurement is 12in. end to center, measure the elbow from the end to the center,usually by putting it on a table or againist a wall, say your meas. is 6in. bear in mind that the elbow will fit over the duct,lets say 2in. that means the elbow will add 4in. to your duct, subtact 4in.from your 12in.meas. that leaves you with 8in. of duct to make your offset

How do you get into the screwed up click?

If it is a really screwed up clique then why would you want to be in it? You need to just be yourself and find friends that like you for who you are.

Where can one find music related to an elbow?

If you are looking for music relating to an elbow, you can try the Elbow band. You can try MP3break website for Elbow Lippy Kids. You might also wish to check on the MTV website or VH1.

How do you calculate 45 degree steel elbow weight-- need a formula?

The easiest way is to find the centerline length and multiply that by the linear weight of the pipe size being used. Alternatively, this formula should give the weight of an elbow in pounds: w=0.071*pi^2*R*(ro^2-ri^2) Where: w= weight of elbow (lb) R=curve radius of elbow (in) ro=outside radius of pipe (in) ri=inside radius of pipe (in)

Where do you find oil filter?

Screwed on the engine block. Get under the vehicle and look around and you will find it.

How do you find your connection type?

We screwed each other on the bed... spongebob!