0.000095meters = 0.095mm Dia of Hair = 0.095 + 10 = 10.095mm Diameter = 10.095mm
The diameter of a pipe is its width across an open end of the pipe. The inside diameter is the width measuring on the inside of the pipe; the outside diameter is the width measuring on the outside.______________________________________________________________________________________________________For a pipe of circular cross section, its nominal diameter is the diameter of the cross section.The inner diameter is the measuring on the inside of the pipeThe outside diameter is the measuring on the outside of the pipe.
It is half the thickness (diameter) of the circular cross-section of the cylinder.
The diameter of a log cannot be determined from its length.
It is the diameter of the circle.
A conic section is a curve formed by the intersection of a plane with a cone (conical surface). If the section is parallel to the base of the cone, the conic section has a fixed diameter and is a circle. Any other plane that does not intersect the apex is either a parabola, a hyperbola, or an ellipse.
At a greater diameter, the cross-section will also be greater, and therefore the resistance will be less. This assumes that other things are equal, of course.
iddk
If you have a physical cylinder to measure, measure the "width" of the circle that is the cross section of the cylinder. That is the diameter, Half the diameter is the radius.
The hydraulic diameter for any cross section is: Dh= 4 * A / Wp Where Dh = hydraulic diameter A = cross sectional area Wp = wetted perimeter
235 / 70 / R16 is : 29 inches in diameter / section width 9.3 inches / section height 6.5 inches --------------------------------------------------------------------------------------------------------- 245 / 75 / R16 is : 30.5 inches in diameter / section width 9.6 inches / section height 7.2 inches
West Mexico
The diameter of a pipe is its width across an open end of the pipe. The inside diameter is the width measuring on the inside of the pipe; the outside diameter is the width measuring on the outside.______________________________________________________________________________________________________For a pipe of circular cross section, its nominal diameter is the diameter of the cross section.The inner diameter is the measuring on the inside of the pipeThe outside diameter is the measuring on the outside of the pipe.
It is half the thickness (diameter) of the circular cross-section of the cylinder.
The diameter of a log cannot be determined from its length.
Yes if cut in half from its apex to its base diameter.
It is the diameter of the circle.
235 / 65 / R17 is ( 29 inches in diameter and the tire section width is 9.3 inches ) 245 / 70 / R18 is ( 31.5 inches in diameter and the section width is 9.6 inches )