the real answer is NOTHING,,, i know u
probably dont believe me but if u try to put that answer and its right
u owe me money=]
Anemometer is an instrument to measure the wind speed.
we want attach stainless steel plate bottom of pressure cooker
It's fairly simple. Build an air-tight container, and attach a vacuum pump to suck the air out. It's a fairly common thing to do, actually. For a more elaborate vacuum chamber, build a second fairly large airtight container and connect the two together with a valve between them. Attach a vacuum pump (or several of them) and "evacuate" the air from the large chamber. Then, when you open the valve between them, the air in the smaller chamber will immediately be sucked out and into the larger chamber, creating an "instant" vacuum.
No, they attach to the outside of the hair follicle.
because water molecules attach to dust particle. when tiny mass of water has formed on a dust particle, other molecules will join the liquid mass.
Why would it be necessary to attach a manometer to the hypsometer
1. Remove the stove top cover and remove one of the burners assemblies.2. Attach the long end of the manometer tube to the burner outlet and turn that valve to the on position.3. Open the valve at the propane tank and then light one of the other burners on the stove top. Once the flame is established and burning steadily turn it off and shut the valve at the propane tank.4. Bleed off the pressure until the manometer reads 8 inches water column. You may want to light a burner to burn off this gas. This is done to equalize the pressure across the regulator, to be sure that more gas is not fed through the regulator to the low pressure side.5. Let everything stand this way for 15 minutes - if the manometer drops any amount, you have a leak in the system.
You need to attach a fuel pressure gauge to the port on the fuel rail to measure the pressure.
Anemometer is an instrument to measure the wind speed.
You could use a ruler to measure its size, or a thermometer to measure its temperature.
You attach a pressure test kit to where the radiator cap goes, and pressurize the system. If it holds pressure, it's good.
The Erlenmeyer flask was named after its creator Emil Erlenmeyer, who was a German chemist. It is a flat bottomed cone-shaped container that has a tapered neck so that a person can hold it, put a stopper on it or attach a clamp with it. This flask is used to measure, mix, and store liquid.
The Home Depot maintains a website dedicated to these pressure washers. I will attach the link below.
the basic plans are simply to attach a 12 gram charger to a pvc pressure holding device, then attach that to a valve, and then a barrel.
allows you to attach a fuel pressure gauge to check fuel pressure, you can also use it to relieve the fuel pressure during maintenance
we want attach stainless steel plate bottom of pressure cooker
Air Probe.