dependent variable
Independent Variable
Good maps are at timetemperature dot com.
i do not care what you stupid idiots want to know
The resistance of a thermistor changes when its temperature changes due to the inherent properties of the thermistor material. In a negative temperature coefficient (NTC) thermistor, the resistance decreases as the temperature increases, whereas in a positive temperature coefficient (PTC) thermistor, the resistance increases as the temperature rises. This change in resistance is caused by the variation in the number of charge carriers (electrons or holes) and their mobility within the material as temperature changes.
Lowering the temperature of a material can change it's molecular structure but it will still basically be the same material because the elements are still there.
Latent
Good maps are at timetemperature dot com.
dependent variable
The cause is the thermal expansion of materials.
Changing the temperature or pressure of a material we can change the phase.
Matter changing state is usually a result of the material changing temperature and/or a change in the surrounded pressure on the material. The change of state is usually associated with a change in its density.
This temperature is called melting point and is different for each substance or material.
Yes. Specific heat capacity is the amount of heat energy required to change the temperature of the material, so a material with high specific heat needs a lot of heat energy for its temperature to go up.
Yes quite possible. This occurs at the change of state. As water gets changed into steam heat will be supplied but the temperature would remain at the boiling temperature.
specific heat content is calculated by the joules of energy required to change the temperature of one cubic centimeter of the material 1 degree Celsius.
i do not care what you stupid idiots want to know
At equilibrium the table ad air will have the same temperature. Any change in air temperature will change the temperature of the table but the change in table temperature will lag behind the change in air temperature. If you feel a table in a room it may feel cooler than the air temperature as the table material is more conductive of the heat from your skin than the air.
Heat raises the temperature of the material. If the change is small then there is only a physical change and allowing the material to return to its original temperature will return it to its original physical state.However, too much heat can result in chemical changes which are usually not reversible. For example, if you heat a piece of plastic enough it will crumple into a charred mass. That charred mass will not return to the pristine plastic.