answersLogoWhite

0


Best Answer

The answer is no, not generally. All that means is I wouldn't do it that way.

It all depends on how much you want to go out if that circuit trips. Having outlets on different circuits isn't as important as having lighting on different circuits. If a lighting circuit trips, and in a home the lighting and outlets share circuits, you don't want every room on that floor to be dark.

So you might consider wiring a room on one floor on the same circuit as the room above or below. That's fine. But if there are 4 rooms in close proximity on the same floor, I wouldn't put all the lighting on one circuit, even though that is an acceptable installation.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it good practice to have outlets on different floors on the same circuit?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

Maximum safe load limits of what must be posted within buildings and structurs?

floors


When taking power from one phase of a 240 Volt circuit to make a 15A 120 Volt circuit how do you fuse the new circuit?

Don't do this! The fuses and breakers on a 240 Volt circuit should be left as they are, to supply 240 Volt appliances and nothing else. It is only safe to install a new 120 volt circuit by fitting a new 15 Amp breaker and run new wiring of the correct size for the length of run, all the way from the breaker panel to the new 120 Volt socket outlet.Before you do this you must check the wiring code for your locality (town/state) to be sure you know if the new circuit needs a protective device such as a GFCI or RCD.In most places a GFCI or RCD will be mandatory if the new socket outlet is to be installed in a place that is likely to be subject to water spray, wet or damp floors, walls or ceilings. This includes kitchens, bathrooms or shower rooms, or anywhere outside the building such as pool areas. As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.


Costs of electric floor heating?

One type of heating for the floors that is a bit less expensive is the geothermal heating. These pumps rely on water pipes that are layed in the subfloor and when water moves through them the heat (or cold for that matter) radiates to the tiles above and generates heat or cooling.


What is interconnect modeling in VLSI?

Building an IC chip (about the size of a fingernail) is like building a multi-storey building. The first floor contains about a billion semiconductor transistors (referred to as "devices"), and the upper floors contain the metal wires that interconnect the terminals of the "devices". These metal wires are extremely narrow, and there is a maze of these criss-crossing multi-layered metal wires in an IC chip, interconnecting the transistor "device" terminals on the first floor (they drop down from an upper layer to a lower layer using "vias"). There is a lot of parasitic (ie. unwanted) capacitance (C), resistance (R) and inductance (L) in/among these cross-crossing interconnect wires and vias. These parasitic C, R and L degrade the characteristics of the IC chip. "Interconnect modeling" deals with the modeling of these C, R and L so that they can be accurately considered in predicting/simulating the overall circuit behavior. "Device modeling" on the other hand deals with modeling the behavior of the transistor devices on the first floor.


When is static electricity come used?

Paint spraying cars: the paint particles are given a negative charge, and the car frame is given a positive charge, so the paint sprays out, and sicks to the car, and is attracted to all the hard- to reach areas Electrosatic precipitator; in coal fired power station theses are used to stop the dust particles reaching the atmosphere. Particles of ass pass through a charged grid, and becone charged. They then stick to plated either side of this grid, where they can be disposed of safely Photocopier; A charged drum is in the photocopier. Light is then shone through the paper, and whete ther is no print light hits the drum and it looses its charge. This leaves charge where there needs to be ink. Ink is the pulled onto the charged drum, and transfered onto paper Antistatic floors; to avoid static charges in hospital, the floors are made out of an antistatic material, so no charge can build up.

Related questions

How do you unlock new floors in icy tower?

get to different floors get higher


How do I go about replacing basement floors?

I want to build a basement floors and I'm not sure where I can find them. Is there is many different selections for basement floors?


How many floors are there in the mansion of Ao Oni?

There are two different floors on the mansion of Ao Oni. The two floors are called the basement and the green floor.


What is the Weight capacity for reinforced concrete floors?

Reinforced concrete floors can be designed for a wide range of loads. Different thicknesses and shapes of concrete and arrangements of reinforcing will have different strengths.


Where can I find information on bamboo floors?

You can get the information about the bamboo floors on internet. I Floor is one of the best flooring website in the world. I Floor provides the best wooden floors in different colors. You can order them for floors in a best reasonable price.


What is a home in a building which contains many different floors?

a hotel lol


What type of products does Floors To Go sell to consumers?

Floors To Go sells different flooring to consumers such as bamboo flooring, different types of wood flooring, tile flooring, and also carpeting for the floor.


What are engineered hardwood floors used for?

Engineered hardwood floors are sturdy floors, specifically designed by engineers to be used for below-grade installations such as basements. These floors are designed to withstand different temperatures since a basement temperature can vary during the summer versus winter time.


What type of carpet does the company Shaw Floors carry?

Shaw Floors specialize in both indoor and outdoor carpets. They aim to provide high-quality and luxury carpets in many different styles and different colors.


How many floors does Pitfall Valley Have?

Pitfall Valley is a dungeon in the game Pokémon mystery dungeon. This dungeon contains 25 different floors that you can go to.


Are spill containment berms useful for painting?

No. When painting all you really need is brushes, rollers, tarps for your floors, tape to put on electrical outlets and anyplace you don't want tape such as wood frames on doorways.


Maria and Manuel are on the first floor of an office building that has 50 floors Maria takes an elevator to the 25th floor Manuel takes a different elevator that stops at the 5th floor?

Maria dident travel farther then Manuel. Maria only travled 25 floors while Manuel traveled 45 floors, between both of them are 40 floors. together they travled 70 floors