That is fairly accurate. I like to use 1.5 times the width of the nut.
My thumb, from the palm-thumb joint to the thumb-tip is 7.0 cm.
Most thumbs are about 2 cm in diameter and about 7cm in height.
Minimum length of splice is determined by local building codes, but a good rule of thumb is to make the splice length at least 20 times the bar diameter, but always at least 18" minimum.
The ratio of the human thumb to the length of the arm is usually 1 to 15. The thumb's length can fit into the size of the arm an approximately 15 times or more.
Your earlobes are always the same length as your thumb.
If you mean the palm of my hand, yup! It is exactly 3 times the length of my thumb. (:
Yes, the length of a thumb is typically measured in millimeters. An adult thumb usually ranges from about 50 to 70 millimeters in length, depending on individual size and anatomy. Measurements can vary widely among different people.
Yes.
50 cm
The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.
The length of a person's hand is not universally three times the length of their thumb; this ratio can vary among individuals. While some people may find their hand length to be approximately three times that of their thumb, others may have different proportions. Generally, hand and thumb sizes are influenced by genetics and individual anatomy. It's best to measure and compare to determine the specific ratio for a person.
diameter is a nother name to get radius if you times the diameter bye the length and widht you should get the radiusdiameter is a nother name to get radius if you times the diameter bye the length and widht you should get the radius