That is fairly accurate. I like to use 1.5 times the width of the nut.
My thumb, from the palm-thumb joint to the thumb-tip is 7.0 cm.
Most thumbs are about 2 cm in diameter and about 7cm in height.
Minimum length of splice is determined by local building codes, but a good rule of thumb is to make the splice length at least 20 times the bar diameter, but always at least 18" minimum.
The ratio of the human thumb to the length of the arm is usually 1 to 15. The thumb's length can fit into the size of the arm an approximately 15 times or more.
Your earlobes are always the same length as your thumb.
If you mean the palm of my hand, yup! It is exactly 3 times the length of my thumb. (:
Yes.
50 cm
The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.The answer will depend on what characteristic of the thumb you wish to measure: length, width, mass, volume, resistance to pressure, etc.
An inch
diameter is a nother name to get radius if you times the diameter bye the length and widht you should get the radiusdiameter is a nother name to get radius if you times the diameter bye the length and widht you should get the radius
Typically, a person's thumb and nose are not the same length; the thumb is usually shorter than the nose. However, this can vary between individuals due to differences in body proportions. On average, the thumb length is about 2-3 inches, while the nose can range from about 2 to 4 inches, depending on the person's size and anatomy.