Want this question answered?
nothing
pi is the ratio of a circle's diameter (the distance across it) to its circumference (the distance around it).
Across the world, very close to 1. However, there are major deviations from that in countries such as India and China - although the reasons are different.
If the ratio of similarity is 310, then the ratio of their area is 96100.
an eqivalent ratio is an ratio that is equal or you can simplfiy it
plz give me answer the above question
In open circuit, find the ratio of voltages across the slip rings in rotor side to the applied stator voltage.
For a transformer, the turns ratio always applies between its primary and secondary windings. So the turns ratio for a three-phase transformer is the ratio of primary to secondary phase voltages, not between line voltages.
Low voltages are not 'combined into higher voltages' for transmission! The lower voltage (e.g. the voltage generated at a power station) is applied to the primary winding of a large power transformer, and the required higher transmission voltage then appears across the transformer's secondary winding. The magnitude of the secondary voltage is determined by the turns ratio of the transformer's windings.
10 dB gain means a voltage ratio of 3.16227766 to 1.
You can't. You need to know both the secondary and the primary voltages to determine the voltage (or turns) ratio.
It depends on the voltage ratio of the transformer. If you know the primary and secondary voltages, then you can work it out for yourself.
Transformer turns ratio is the ratio of voltages between two windings. For instance, a 24VAC control transformer that runs on 120VAC will have a turns ratio about 5 to 1.
The voltage ratio of a potential, or voltage, transformer (PT or VT) depends upon the primary voltage to which it is connected. Accordingly, its voltage ratio varies considerably, as there is huge variety of system voltages throughout the world.Typically a VT's secondary voltage is standardised at 110 V which will match the full-scale deflection of a voltmeter connected to it (although it can also supply protective relays), while its primary voltage is then matched to the voltage of the system to which it is connected: in the UK, for example:11-kV:110 V33-kV:110 Vetc.
if the resistance of bulb A is 2x that of B then there will be twice as much voltage across it (ratio 2:1 ). both voltages shall equal the system voltage assuming they are in series and there are no other components in the circuit if the bulbs are in parallel the voltage across them will be equal and that of the system
I=V/R, current = voltage divided by resistanceAnswerOhm's Law states that 'the current flowing through a conductor, at constant temperature, is directly proportional to the potential difference across the conductor'.Ohm's Law only applies when the ratio of voltage to current is constant over a wide range of voltages. If the ratio changes, then Ohm's Law does not apply.
nothing