It depends on the color coding standards for what country you are in.
In the US, the answer is no. The Neutral (white wire) is grounded at the service entrance to the building. The black wire should have roughly the same voltage to the neutral and to the ground.
Something to be aware of: If you are using a meter and checking for continuity between the black wire and ground, it may tell you that they have continuity if the breaker is on.
You don't say "turn off" or turn on". Light should be connected black to black and white to white and ground to ground. If you connect white to ground it will work, but you are then using the ground wire for an unintended purpose. Neutral is bonded to Ground at the panel. Current on ground wire could cause ground loops and may cause GFCI to trip if you have them in your house.
in a home noin a car yes
Ground wire can be appropriately bonded to the neutral and cabinet at the service box by connecting the neutral and ground wires from the feeder wires to the neutral bus bar and the ground terminal located on the same cabinet at the service box. White wire (neutral) must be connected to bus bar and bare wire must be connected to ground terminal in the same cabinet.
the green wire its ground so you have black withe an ground
The Dark Green Wire should be the hot to the air compressor clutch and Black should be ground.
You don't say "turn off" or turn on". Light should be connected black to black and white to white and ground to ground. If you connect white to ground it will work, but you are then using the ground wire for an unintended purpose. Neutral is bonded to Ground at the panel. Current on ground wire could cause ground loops and may cause GFCI to trip if you have them in your house.
No. Green should always signify the ground wire.
Easy, Ground it with your stereo ground wire.... (make the pink wire and black wire connect to the Main Ground wire which is also Black)
If you are connecting 120 volts, you connect the black wire to the breaker, white wire to the neutral bar, and ground wire to the ground bar. If you are connecting 240 volts connect the black & white wires to the breaker, & ground wire to the ground bar.
in a home noin a car yes
The problem sounds like the water pipe is not bonded to the ground wire of the distribution. These two wires should have a potential of zero between them once they are bonded together as per electrical code recommendations.This must be an older installation as nowadays most new water pipe installations use PVC to service a water supply to the home. In this case the PVC water supply pipe does not need to be bonded to the ground wire of the distribution service.
Ground wire can be appropriately bonded to the neutral and cabinet at the service box by connecting the neutral and ground wires from the feeder wires to the neutral bus bar and the ground terminal located on the same cabinet at the service box. White wire (neutral) must be connected to bus bar and bare wire must be connected to ground terminal in the same cabinet.
the green wire its ground so you have black withe an ground
fff
The Dark Green Wire should be the hot to the air compressor clutch and Black should be ground.
Negative - (Black) is Ground, Positive + (Red) is Hot. Ground wire goes to Negative (Black) it goes from negative on battery to engine for ground.
The neutral is the ground The neutral is NOT the ground. The ground is defined by a third bare or green wire in some cases. Look in the back of the receptacles junction box. See if the ground wire is bonded to the box but was not long enough to bring it out to the receptacle. With a tester you can check to see if the box is grounded. Place the testers red probe on to the black wire and the black probe on to the electrical box if it is a metallic box. If a voltage is noted, then the box is grounded. When the receptacle is reinstalled the ground will be picked up through the mounting screws. Or you can extend the ground wire at the back of the box and connect it to the green ground screw on the receptacle. If you have any doubts about an answer that you get, check the answerer's bio by clicking on their name to check their qualifications.