It would be green or bare. That's if you have a grounding wire in the cable. You may not have one.
A four blade dryer plug cord should have a red, black, white, and green wire in the cord set. The red and black wires are the ones that deliver the 240 volts to the dryer. Black and white deliver control 120 volts to the dryer and also drive the motor to turn the dryer drum. On some dryers they use the red and white for the motor and black and white for the control. As for the green it is always the ground wire.
In a typical dryer plug, the two hot wires are usually the red and black wires. The white wire is typically the neutral wire and the green or bare wire is the ground wire. Always consult the manufacturer's instructions to be sure.
You will have to check to make sure. Normally, with 4 wires, the black and red are both power for 220. White for neutral and bare for ground. If you are only using one leg of it, you would use the black, white, bare ones and cap the red one. Someone may have used the 4 strand because they had it or 220 was planned but not done or both the red and black are hot. You should be able to tell in the panel. Do the red and black both connect to separate breakers or to one or is the red not connected?
A dryer needs four wires for proper operation and safety because it requires two hot wires, one neutral wire, and one ground wire. The ground wire helps protect against electrical shocks and ensures proper functioning of the appliance. It is a standard requirement to have all four wires for dryer installations to meet safety regulations.
There are more white dwarfs. Only the most massive stars can form black holes. White dwarfs form from low to medium mass stars, which far outnumber the supermassive ones.
A four blade dryer plug cord should have a red, black, white, and green wire in the cord set. The red and black wires are the ones that deliver the 240 volts to the dryer. Black and white deliver control 120 volts to the dryer and also drive the motor to turn the dryer drum. On some dryers they use the red and white for the motor and black and white for the control. As for the green it is always the ground wire.
In a typical dryer plug, the two hot wires are usually the red and black wires. The white wire is typically the neutral wire and the green or bare wire is the ground wire. Always consult the manufacturer's instructions to be sure.
when you have the nat dex, you can see every pokemon in the universe except from the ones in black and white. so the ones from black and white are the only ones you cant see
Yes there's black ones White ones and yellow Ones .
You will have to check to make sure. Normally, with 4 wires, the black and red are both power for 220. White for neutral and bare for ground. If you are only using one leg of it, you would use the black, white, bare ones and cap the red one. Someone may have used the 4 strand because they had it or 220 was planned but not done or both the red and black are hot. You should be able to tell in the panel. Do the red and black both connect to separate breakers or to one or is the red not connected?
A dryer needs four wires for proper operation and safety because it requires two hot wires, one neutral wire, and one ground wire. The ground wire helps protect against electrical shocks and ensures proper functioning of the appliance. It is a standard requirement to have all four wires for dryer installations to meet safety regulations.
No. Some have white rumps, others have patchy black-and-white rumps. A few have black ones.
well the black ones run faster.. so i guessing the white..
the white ones are racist
Yes there are black ones and they look good too.
In positions superior to the black ones.
They can be recognized by the color of their feet. White big foot typically has white big feet and the black one has black ones.