Yes indeedy, if any of your electrical wiring is behind wall/floor/ceiling covering such as dry wall, plaster, tile or wood. The LICENSED electrician needs to see your connections to determine not only what problem u might have, but also to see how to correct it. NOTE: Most local governments (Canada & USA) require a gov't permit before any wiring or re-wiring is done. If your contractor doesn't get one, u can. If the work is done and not covered up, ask for an official inspector. Call your city hall to find out. Hope this helps.
Charge runs between the poles when you connect them with a circuit, or leaks out slowly through parasitic internal paths. Don't expect to light an LED very long, though there are configurations where a few seconds are possible. Of course they should not be self-heating, nor is it good for them to be subject to substantial heat from other sources
While one might expect a latin symbol for amperes or milliamps, A and mA are the accepted symbols for these.
I suppose you could answer that it was the occasion when you blew all the fuses, but then again I would expect YOUR views about what YOU did would make a better answer.
Make sure the the Leeds are inserted in the right hole. Make sure that the meter is set to the range of voltage or current you expect
if you reverse the diode in a half wave rectifier, you would expect the A- Ripple to increase B- output to be less filtered C- out put polarity to be reversed D- output voltage to decrease
Ten percent is an average amount that you can pay a general contractor. You shouldn't pay more than this as many people are willing to work for this percentage or less.
First. Expect another 5 months.
The range for bathtub refinishing work from a licensed and bonded contractor varies, but you can expect to pay anywhere from $340 to $900 total. This amounts to approximately $1.50 to $4 per square foot. You should definitely check someones credentials and sign a contract before ever agreeing to pay someone for their work.
It depends on the design of the desired pool, and the contractor who you hire. The average cost of a medium in-ground pool with no frills is $30,000.
Low gas contnt and low viscositymagmas.
If you hire a licensed contractor expect to pay around $5,000.
This would depend on what you order as you could have instructed the contractor to make all seams seamless (hidden). You would not expect to see them no. As if you had asked the contractor would have been able to tell you if he could do it or not and their reasons why. It would take more work to make them seamless.
At least a conversation. (about?)
First of all, make sure your contractor is licensed, bonded and insured before signing on the dotted line. The general contractor usually hires all the subcontractors which are your plumbers, electricians and carpenters and you will want to get in writing, from him, that all of them are properly licensed/trained for the jobs they are doing.
If the work done had to be done to comply with local statutes and regulations then yes he/she can
There are many things you should expect in a hotel room. You should expect a window, a bed, and a bathroom.
My puppy of 6 months was spayed today and they nicked the bladder during the operation. Is that a big problem and what should I expect and watch for?