Use a 20 amp fuse or breaker.
Normally it is a 20 amp using AWG 12/2 gauge wire. But it really depends on what size wire is on that circuit. If it is white AWG 14 gauge then use a 15 amp breaker. If it is yellow AWG 12 gauge then use a 20 amp breaker.
AWG 12 will suffice.
You need to know the amperage to size the wire. For 220 V at 20 A you would need 12 AWG. At 220 V at 30 A 10 AWG.
12 AWG.
The size breaker you use is determined by the size wire used in the circuit. If you use AWG #12/2 wire then use a 20 amp breaker. If you use AWG # 14/2 then use a 15 amp breaker.
The correct size fuse needed is based on the size wire used in the circuit. The size wire needed is based on the load that will be applied to the circuit. 1. AWG 14/2 wire = 15 amp fuse 2. AWG 12/2 wire = 20 amp fuse 3. AWG 10/2 wire = 30 amp fuse 4. AWG 8/2 wire = 40 amp fuse
Size 12 in the American Wire Guage (AWG). It's a wire of about 1/10 inch diameter.
I think you mean either what is the correct size or minimum wire size needed when a branch circuit is protected by a 20 A breaker. The size is 12 American Wire gauge (AWG). 14 AWG is used for 15 A circuit and 10 AWG for a 30 A breaker. The lower the gauge the larger the cross-section of the wire.
There are multiple fuses in your car protecting various loads. Wire gauge depends on load. The gauge or wire for the battery might be 8 AWG to handle high cranking currents for starter motor. 14 AWG wire might be employed for loads requiring 15 amps or less and so forth.
12 AWG.
12 awg is larger.
Normally it is a 20 amp using AWG 12/2 gauge wire. But it really depends on what size wire is on that circuit. If it is white AWG 14 gauge then use a 15 amp breaker. If it is yellow AWG 12 gauge then use a 20 amp breaker.
AWG 12 will suffice.
Look on the heater and see what amps it is pulling. That will determine the wire size and breaker size. It must be on a dedicated circuit. 15 amps = AWG # 14 wire with 15 amp breaker 20 amps = AWG # 12 wire with 20 amp breaker 30 amps = AWG # 10 wire with 30 amp breaker 40 amps = AWG # 8 wire with 40 amp breaker
You need to know the amperage to size the wire. For 220 V at 20 A you would need 12 AWG. At 220 V at 30 A 10 AWG.
Yes, 12 AWG is good for 25 Amps if copper wire.If aluminum wire, then good for 20 Amps.
You use the correct size breaker depending on the size wire in the circuit. If the circuit is wired with AWG #12 wire use a 20 amp breaker. If it is wired with AWG #14 wire then use a 15 amp breaker.