0
True trac meter is reading different results every time what is wrong with the meter?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you provide a meter reading?
where do you go on your website to notify you of meter reading
What is the smallest reading on the meter rule?
0.5
What turns back to zero?
the number on the digital electric meter after the reading
What instrument would give a reading of 53 percent?
humidity meter
How do you know how many centimeters are in a meter?
Every 100cm makes 1 meter
How do you provide a meter reading?
where do you go on your website to notify you of meter reading
How do you use a volt meter to test the heater on a spa?
Turn on the voltmeter and attach a probe to different terminals on each component for a reading. What you do with the results is up to you if you are a heater tech. If you do not know how to use a voltmeter - you are already in trouble.
How do you get meter reading?
You can get a meter reading by looking at the BIG circle thing that does be outside of the house and it will say 88888 and then say another number which is the meter reading.
How you can edit your car meter reading?
how can recet the meter
Why does 120 volt outlet read 145 volts on meter?
A reading of 145 volts is high. The first thing that I would check is the accuracy of your meter. Check the voltage reading at different locations for example, friends homes, to see if the reading is still high there. If it is check your meter reading against another meter. If you are sure that your meter and reading is correct then call the utility company and get them to check the voltage for you.
How is electricity charged from the power company?
It is usually charged by the kilowatt hour which the company gets from reading your meter every month.
What will happen if we use current transformer of different rating for each phase in three phase supply?
A current transformer has to have the same ratio as the meter that it drives. Full scale deflection on the meter is 5 amps which equals the maximum allowed current on the phase that it is reading. A different ratio on the CT to meter would show an erroneous reading on the meter depending on the ratio of the connected CT. To keep costs down the meter is common to all three phases and is read by connecting the meter to the phase CT through a three position switch.
Why it is essential for voltmeters to have a very high resistance?
if the resistance of the meter is low that will act as a parallel load effecting the reading. If the meter can be made with infinite resistance then the meter will not effects the actual reading.
How does a digital multimeter eliminate parallax error?
When reading the needle on an analog meter, you can get a slightly different reading depending on the position of your eye relative to the needle and the scale behind the needle. This is parallax. The digital meter reads the exact value measured (to the accuracy of the meter), and then displays it in the form of "numbers" or "digits" so your eye is not interpreting the value from a scale.
Is automatic meter reading implemented in India?
NO
What is the smallest reading on the meter rule?
0.5
How do you calibirate the TDS meter?
To test a calibrate TDS meter has a few steps. First lightly tap or stir the meter that will remove any air bubbles, wait ten to twenty seconds and read the stabilize, for more accuracy readings turn the meter off the meter after each reading and shake off all the water after every use.
