refer to table d3 of cec 2009 for proper calculations,need to know your current, wire size etc.refer to distance correction factor (dcf) formula supplied in cec (canadian electrical code)
Go to find the three missing items. You will find the pig in an underground chamber -- drop into the manhole on Main Street.
You should already have the robot crab from when you got Sully's key. You also need a length of vine that is atop the building to the left of the Living Quarters. Go right to the Hub at the right of Main Street. Use Sprocket to drop the robot crab on the "hot hatch" to cool it off, so you can enter the underground.
I think R2 on PS2
the length of drop on Jurassic Park-The Ride
Its where you plug a stove into. Power drop for what?? Voltage drop deals with wire size and length.
a drop three means its like a 33 inch bat and 30 ounce bat and if you minuts 30 from 33 you get -3 which means drop three. I know because we use them in Junior High.
'Drop' is a term used with bats and is the difference in the weight and length of a bat. Subtract the length (in inches) from the weight (in ounces) to determine the drop. A bat that is 30 inches long and weighs 35 ounces would have a drop of 5. A bat that is 35 inches long and weighs 30 ounces would have a drop of -5. Most bats have a negative drop.
It stands for drop 10. The drop of a bat depends on what the length and weight is. You find out the drop by subtracting the weight from the length. So if your bat was 32 inches long and 22 ounces then it would be drop 10 (-10) if your bat was 32 inches and 25 ounces then it would be drop 7 (-7)
When the length of the wire increases voltage drop across the wire will occur.There are two factors that can result in voltage drop. One diameter of the wire, two length of the wire.Voltage drop increases with increase in length of wire, whereas voltage drop decreases with increase in diameter (cross section area) of the wire.G.RAOAnswerIf you are asking what happens to the voltage across a length of wire when its length increases, the answer is nothinghappens! The voltage applied to the wire is determined by the supply, not by the load (i.e. the wire).
The drop of the bat is the difference between the length minus the weight. For example, if a bat is 33" long and it weighs 30 ounces, then the drop is -3. The drop of the bat varies in baseball, depending on the level of play. Little League doesn't have any regulations for the drop zone. Senior League baseball (ages 10 - 14) has a drop zone regulation of no lighter than -8. High school baseball has a drop zone regulation of no lighter than -3. College baseball has a drop zone regulation of no lighter than -3.
To answer this question a voltage must be given.
The wire resistance is proportional to the length of wire divided by its cross-section area. The voltage drop is proportional to the resistance times the current.