Amps is short for ampere, a unit for current.
amps are useless
The electrical current in a circuit is measured in amps.
This depends on your local electrical code, however the National Electrical Code and Canadian Electrical Code both state that you must derate circuits to 80% of their maximum electrical capacity, so for a load of 75 amps you must use overcurrent protection and wire rated for 93.5 amps, and since that doesn't exist you must upsize to 100 amps.
In the electrical trade the only time there is a reference to start and running amps is when dealing with motors. The running amps is always lower than the starting amps. A 78 amp electric furnace will take a 100 amp service for it to operate and be within the electrical code guide lines.
Electrical current can be measured with an Ammeter. The units used are amps.
Conductivity - is measure in inverse amps.
The electrical current in a circuit is measured in amps.
An electrical ammeter.
Amperage or Amps is a measure of is the flow rate of electrical current that is available.
12 amps of electricity.
An electrical device may draw amps, but there is not a device that equates to amps. Amperes are the measure of current flow in a circuit.
Amps, or amperes, are a measure of electrical current; ohms are a measure of electrical resistance. Both are widely used in physics.
Amperes(amps)
This depends on your local electrical code, however the National Electrical Code and Canadian Electrical Code both state that you must derate circuits to 80% of their maximum electrical capacity, so for a load of 75 amps you must use overcurrent protection and wire rated for 93.5 amps, and since that doesn't exist you must upsize to 100 amps.
If the electrical contractor has all of the materials ready for the job, the man hours should be about eight hours.
Volts x Amps = watts
full load amps
Watts = Amps x Volts.