answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What are the point gaps for mercruiser 470?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the correct ignition timing for a mercruiser 470 engine?

Timing for Mercruiser 470 is 8 BTDC at idle speed. Mercruiser Service Bulletin specifies 4 degrees BTDC, due to new gasoline formulation.


What is the dwell for a mercruiser 470?

34-36 degrees Sterndrives.com


What fram oil filter fits the mercruiser 470?

ph5


What is the propeller size for a mercruiser 470?

the stock size is a 14.75 x 21 ptich


Where is the resistor for the coil on a mercruiser 470?

The Cable is the Resistor ! Its a Resistor-Cable ! Greets from the Lake of Constance/Germany !


What is the point gap setting 3.0 l mercruiser?

.022 gap with a feeler gauge.


What is the boiling point of the element californium?

The boiling point of californium is 1 470 0C.


Is a mercruiser the same as a Chevy engine?

Mercruiser buys engines from many suppliers, including Chevrolet.


How do you write 470 as a fraction mixed number or whole number in simplest form?

I suspect that there is a missing % after the 470 (due to limitations with URLs, Answers unfortuantely strips out any character that is not a number, letter, hyphen or decimal point). In that case you are asking about 470% "percent" means "out of 100" → 470% = 470/100 = 47/10 = 4 7/10


What is the correct ignition timing for a mercruiser 3.0 engine?

The correct timing for a Mercruiser 3.0L 140 engine is 6 degrees BTDC. for a Mercruiser 120 the correct timing is 8 degree BTDC.


You have twin mercruiser engines on your boat you are losing antifreeze but you are not sure from where about a gallon for every 2 hours run time There is no antifreeze leaking from any part of the en?

if these engines are of the 470 mercruiser family check the seal behind the water circulating pump on front of engine is anti freeze oily if so check that specific engine ,heat exchangers ? or head gaskets are a good posibilty ! have a compression test done !


Can you get braces when your teeth are not crooked?

if you have gaps but otherwise there would be no point in getting them.