0
What are the requirements for expansion joints on rigid conduit in an underground installation?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Electrical conduit length is there a tool to measuring the conduit underground?
Well yes there is its called electricians conduit measuring tool we found it on u tube . go to superconduits and watch the video .
Do you have to run wiring in conduit if its in the ground?
Wire in conduit for underground feeders has to have an insulationrating for wet and damp locations. In the marketplace there is also wiring thathas an insulation rating for direct burial that does not need to be installed into conduit.
Can branch circuits from a panel be pulled in the same conduit if not exeeding the conduit fill requirements?
Yes. The thing that has to be closely watched is the load on the conductors. The conductors will have to be de-rated as the code only gives amperage rating for three conductors in a raceway. So watch the connected amperage to each load and fill the conduit accordingly. This supersedes the conduit fill requirements rule.
What is the PEC requirements on the number of bends allowed in a conduit run?
4 quarter bend
Can you run two 2 pole single phase circuits in the same conduit?
Yes, this only adds up to four wires. The wire sizing is dependant on the amperage of the two single phase loads. Remember to calculate the conduit fill of the four wires to make sure that you have the correct size conduit for the installation.
Which conduit is best - PVC or MS conduit?
For underground conduit runs, PVC is by far the better of the two conduit systems.
What is rigid conduit and where is rigid used?
There are two types of rigid conduit systems. One is PVC rigid conduit. It is mostly used in underground installations and in in areas that contain water or corrosive chemicals. The second type of rigid conduit is steel conduit. In Canada it is mostly phased out due to the high installation labour costs. Small installations are still used in small explosion proof areas.Both types of systems in Canada have been replaced with Tech armoured cable. Installation costs are lower and the wire is in the cable set, so no wires to pull. It is approved for above grade and underground direct burial installations. Tech also has been approved in explosion proof areas when used with the proper explosion proof end connectors to seal the cable.
Can you list the different PVC conduit fittings?
ma - male adapter, fa - female adapter, coup - coupling, conn - connector, cap - end cap, reducer - bushings that reduce the size of a conduit to allow connection to a smaller size conduit, expansion joints - to allow the expansion and contraction in the conduit system.
Electrical conduit length is there a tool to measuring the conduit underground?
Well yes there is its called electricians conduit measuring tool we found it on u tube . go to superconduits and watch the video .
Can you use PVC conduit underground?
PVC conduit is recommended for underground installations. Just remember that a ground wire equal to the maximum load current of the device connected at the other end has to be installed. This ground wire is not counted in conduit fill calculations. It has to have a green insulation in colour and be of a continuous length.
Do you have to run wiring in conduit if its in the ground?
Wire in conduit for underground feeders has to have an insulationrating for wet and damp locations. In the marketplace there is also wiring thathas an insulation rating for direct burial that does not need to be installed into conduit.
What is the acceptable insulation resistance megger reading of 160 linear feet of 350 MCM copper underground cable phase to phase phase to neutral and phase to ground?
Engineers that I have worked with state in their specifications that all meggered wires must have a reading of 5 Meg ohms or higher. If the reading is lower that this benchmark start checking splices especially if it is an underground installation. Water usually accumulates in underground conduit systems and when the wires are pulled in there is a certain amount of conductor scraping. This starts the downward spiral from infinity. Check termination points close to the exit point of the conduit. A certain amount of evaporation from the conduit condensates on the terminal points.
Can branch circuits from a panel be pulled in the same conduit if not exeeding the conduit fill requirements?
Yes. The thing that has to be closely watched is the load on the conductors. The conductors will have to be de-rated as the code only gives amperage rating for three conductors in a raceway. So watch the connected amperage to each load and fill the conduit accordingly. This supersedes the conduit fill requirements rule.
Can you run Ethernet out doors or should it be incased in conduit?
The outer casing of an Ethernet cable does not have a UV rating and will deteriorate under the summer sun. Pull the cable into a conduit and if possible bury the conduit underground. This will give you a safe and secure link.
The best time to install conduit is when you're?
The best time to install conduit is before the plumbers and sheet metal trades get into the building. <<>> In underground installations before the trench gets back filled.
When the best time to install a conduit?
The best time to install conduit is before the plumbers and sheet metal trades get into the building. <<>> In underground installations before the trench gets back filled.
What are some examples of a plastic conduit?
Plastic conduit is commonly used as tubing in electrical work. It is commonly used underground between buildings, as plastic offers a lower cost solution.
