30,60,100,200,400 and 600 amp
Watts = Volts x Current5 x 300 = 1500 = 120 x AmpsAmps = 1500 / 120 = 12.5 ampsJust install a standard wall switch rated at least 15 amps at 120 VAC. All lights are in parallel and fed from a single switch.
The switch will use no wattage whatsoever. The load on that switch is what uses power. If you know the load is 5 amps then 5 amps at 120 volts is 600 watts.
10 amps 250 volts or 16 amps 250 volts.
200 amps
Canada and US - Standard size breaker in home panel is 40 amps for stove. If not standard range open Discuss Question page.
A safety switch does not provide overload or over current protection. The safety switch is positioned just before the motor and just after the motor protection equipment. To wire a safety switch, the line in from the motor protection goes to the top of the switch and the motor load connects to the bottom of the safety switch. The switch must have at minimum of a 240 volt rating and have an amperage rating of not less than 30 amps. Wire sizing for the connection will be #10 conductor which has a rating of 30 amps.
15 amps
It depends on the particular switch. The ones you can find at Radio Shack, for example, vary from 3 amps to 50 amps.
About 0.6 amps for a 12v 21w bulb
Watts = Volts x Current5 x 300 = 1500 = 120 x AmpsAmps = 1500 / 120 = 12.5 ampsJust install a standard wall switch rated at least 15 amps at 120 VAC. All lights are in parallel and fed from a single switch.
If we assume that you are using a common 15 Amp lighting circuit and switch and using 120 volts to power the bulbs then you need to keep the wattage at 80% of 15 amp worse case or 12 amps. Watts = amps x volts for standard incandescent bulbs. 12 x 120 = 1440 watts.
The switch will use no wattage whatsoever. The load on that switch is what uses power. If you know the load is 5 amps then 5 amps at 120 volts is 600 watts.
volts X amps = watts standard 120 X 15 amps =1800watts microwaves generally use about 1000 watts which is 8.33 amps...
10 amps 250 volts or 16 amps 250 volts.
To answer this question the voltage must be known. Watts = Amps x Volts.
5 Amps. If the current passing through the fuse exceeds 5 Amps is should "blow".
CHMIS is not a standard electrical acronym.