0
What causes intermittent continuity between ground and neutral?
Wiki User
∙ 13y ago
Answer for USA, Canada and countries running a 60 Hz supply service.
When installed properly, there should always be continuity between ground and neutral because they are bonded together at the service. If continuity is intermittent, something is loose. I would start by checking your bond in the service panel
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Why are the brushes of a dc machine always placed at the neutral points?
The function of brush is to collect current from rotating commutator and supplies the current to external stationary load. The brushes of a DC machine are placed at neutral points because the current in the rotating part drops to zero at the neutral point. If brushes are placed in location other than the neutral points, then the current may be switched off and it causes magnetic field and it may also create voltage spikes and arc at brushes.
Armature reaction in a DC generator?
ARMATURE REACTION in DC MachineAll current-carrying conductors produce magnetic fields. The magnetic field produced by current in the armature of a dc generator affects the flux pattern and distorts the main field. This distortion causes a shift in the neutral plane, which affects commutation. This change in the neutral plane and the reaction of the magnetic field is called armature reaction.
What is the difference between the input bias current and the input offset current?
A: difference in bias current causes the other
Why is the outlet 86 volts instead of 120 in your outlet?
There may be an "open neutral" somewhere either in your breaker panel or in the meter base. Contact a qualified electrician to help solve the problem. An open neutral causes one leg of the electrical service to be "low" voltage, while the other leg goes "high". That can result in premature failure of electrical components, such as light bulbs, electronic devices and electric motors.
Drift speed in a conductor that carries current?
The Drift Speed is less than the average speed of the electron between two collisions. Electrons move relatively slowly along a wire but very quickly between collisions. The electric field (EMF) that causes the motion moves at the speed of light.
Any suggestions for causes of intermittent failure to start replaced starter battery ignition switch and the relay?
Check your neutral safety switch on the transmission. It is either loose or out by a hair, that is why it work only some times.
What causes an intermittent burning smell after parking?
take it easier on the clutch as your reversing
What causes windshield wipers to come on inadvertently?
Probably because your wipers are on intermittent.
What causes intermittent shake while driving?
Wheel balance may be off...
What causes the speedometer to be intermittent on a 1997 Ford Taurus and how is it fixed?
Have the speed sensor replaced.
What causes the air bag light to turn on and off while driving a 2005 dodge ram?
There is an intermittent failure in the safety restraint system. You will need to have the system checked for codes to know possible causes.There is an intermittent failure in the safety restraint system. You will need to have the system checked for codes to know possible causes.
What causes a clicking sound near the dashboard inside your car and your ignition to be intermittent?
A bad starter
Intermittent wiper relay?
The intermittent wiper relay is helpful when only a light rain or mist is present. It causes the wiper motor to only operate once every few seconds.
What causes intermittent power steering loss?
Check power steering fluid first, then take it to the shop if it is full.
What causes intermittent pressure or pulling sensation behind one eye?
One possible cause of intermittent pressure or pulling behind 1 eye is problems with the sinuses. Allergies can also cause pressure behind the eye.
What causes intermittent or dark reading on digital speedo display for 1985 regal?
The most likely cause of 'dark' and 'intermittent' responses from a digital display is when the individual bulbs at the back are making bad electrical connection with the ribbon-loom
What kind of arrangement causes an atom to become neutral?
an atom becomes neutral if the atom has an equal number of electrons and protons.
