Want this question answered?
There are several countries in which the minor currency unit is a penny - including the US where a cent is called a penny!The UK penny has a diameter of 20.3 mm.
The longest distance across a circle is its diameter and the shortest distance is a minor chord
It is approx 39.31 square cm.
The circumference of a circle is 360 degrees. The circumference of a circle is also 2*pi*radius or diameter*pi.
The answer depends on which country's penny the question is about. Many countries use a penny as a minor currency unit and since you have not bothered to share the name of the country, I cannot provide a more useful answer.
the minor diameter should fall between 4.917mm - 5.153mm
The major axes of an ellipse is its longest diameter. The minor axes, on the other hand, is the shortest diameter.
the minor diameter should be between 4.917mm and 5.153 mm, so the largest allowable size is 5.153mm
1,000 kilometers in diameter.
The stress on a bolt under longitudinal force is the total force on the bolt divided by the stress area. The stress area is a little bigger than the minor diameter area, calculated from the average of the minor diameter and pitch diameter. The total force on the bolt is its torque preload plus the (bolt stiffness/(bolt +member stiffness) x (externally applied load )
The major and minor axes of a circle are the same - either is any diameter. So a semimajor axis is half the diameter which is 12 cm.
There are all sorts of screw diameters - major, minor, pitch, mean, etc., but in general a screw diameter is a called by its nominal diameter which is the major diameter of the screw, approximately. For example a 1/2 inch screw has a nominal diameter of 1/2 inch.
There are several countries in which the minor currency unit is a penny - including the US where a cent is called a penny!The UK penny has a diameter of 20.3 mm.
Mercury. It has a diameter of around 4880km, while Earths diameter is 12104 km on average.
Only Mercury (Pluto also was in there, but it's now a "minor planet).
ForgingForging Blank send to MachiningPreturning Inner Diameter & widthCNC Ist Set up for Outer Diameter & WidthCNC II nd Set up for Outer Diameter & widthHobbing DOPBroaching Minor IDChamferingDeburring
The longest distance across a circle is its diameter and the shortest distance is a minor chord