Want this question answered?
Some of these switches are easily set by using a "ball point pen" or a paperclip. If you are asking where to set the switches, I need additional specifics about the equipment.
Yes.
set the dip switches on the back to low pass filter and put limiter on to save overdriving
Ground yourself.
Set all the dip switches to match the new board. Detach the baseÊfrom the T-stat. There are a lot of combinations that you can use. Identify what colors are connected to what terminals on the condenser and stat. Also ensure the the settings of the dip switches are correct.
Answer: If your receiver have three decoders build in you can set the code differently, if it only have one decoder you set the dip switches on the sensors the same as the receiver, but then the receiver won't be able to identify the sensors, it won't be able to tell what sensor send the signal. This problem can be solved by using a micro processor system like the Multi Zone from Micro Developments that can identify 65535 different sensors and there is no dip switches to set each sensors code and ID is pre programmed on the sensor
On the back of the motor head hanging from the ceiling, there will be a green button(learn button). Tap this button like a door bell **DO NOT HOLD**, then click and hold the corresponding button you want to use on your remote for 3-4 sec.
Could be the tach is set for 6 cylinders?
If it has dip switches inside you just need to set them the same as your receiver on the opener, otherwise you can use the learn option on the opener to make it learn the new remote.
# You are going to have to open up your vending machine door. In there you are going to find the control panel. On that control panel there is going to be a little button. Press that button # Now return to the front of your vending machine. On the display you will find that it says "HD". # At this point we are going to press the top 2 selection button together. This will change the menu display on the LED to "RD" and if you press them again it will display "SP" for Set Price. # This is the menu option that we are going to use to set the prices on the machine. # Press the selection that you want to change by pressing and holding the button and you will see a price on the display and it will increase. Stop when you get to the price that you want. # Repeat Step 5 for any other selection that you want. # Close the vending machine door and you are all set.
Thermostat
they are set manually by switches or specified as parameters in software.