I just had an MRI done and one of the comments was that an area of the scan showed a low signal intensity...as in, something is wrong with the tissue. I just had an MRI done and one of the comments was that an area of the scan showed a low signal intensity...as in, something is wrong with the tissue.
A T1 line speed refers to the speed at which a T1 line is able to transfer data., often written in kilobytes per second. T1 lines these days see less use and have been replaced with fiber optics.
The purpose of a line-side T1 is to directly connect two devices, using a T1, without going through a service provider. This is done in lieu of using analog circuits or if IP connectivity/trunking is not available. For example, a fax server can connect directly to a corporate PBX, via a line side T1, using a cross-over 2-pair, 22 AWG shielded twisted pair cable. This is a direct connection from the PBX's T1 card to the fax server's T1 card. Provisioning of the T1 circuit is done in both the PBX and the fax server to accommodate the medium (24 channels, robbed-bit signaling).
T1 transmits at about 1550 kilo bits per second; T3 around 6500 kbps.
T1 line
Peripheral neurons are bundled together to make up the 31 pairs.Each pair of nerves is named for the vertebra from which it exits. T1-12. These nerves enter from the thoracic or chest vertebrae.
T1 is a term used in describing MRI results to denote the signal that makes the more fatty areas bright.
7db per 1000ft at 722khz
T1 and T2 can refer to the Thoracic vertebrae (part of your spine). But I don't know what 'low' would imply.
7db per 1000ft at 722khz
24 DSO equal T1
NRZ
A T1 line speed refers to the speed at which a T1 line is able to transfer data., often written in kilobytes per second. T1 lines these days see less use and have been replaced with fiber optics.
It is very likely to be a hemangioma- a benign collection of vessels.
The maximum data rate to T1 carrier is 1.544Mbps, so we have: 50000*log2(1+S/N) = 1544000 log2(1+S/N) = 30.88 1+S/N = 1976087933 S/N = 1976087932 So the signal-to-noise is 10*lg1976087932 = 93db
There are a number of different encoding methods used on T1 lines. Alternate Mark Inversion (AMI), Bipolar With 8-Bit Substitution (B8ZS), and High Density Bipolar Three Code (HDB3).
There are 24 T1's in a T1. www.intelletrace.com
The SHLD (Store H&L Direct) instruction takes 5 machine cycles and 16 clock states, not including any wait states. Opcode fetch: T1, T2, T3, and TX Low order address fetch: T1, T2, T3 High order address fetch: T1, T2, T3 Store L: T1, T2, T3 Store H: T1, T2, T3