Want this question answered?
Drivers side, front to rear, 1,3,5,7. Pass, front to rear 2,4,6,8.
Open the bolt and rack it back. Hold back the trigger. The bolt should slide easily backwards until it detaches from the rifle. If you have a rear sight that blocks the bolt from being removed, simply rotate the bolt handle clock-wise to get it passed the sight and remove as usual.
it could be the abbreviation of 'arrière' (back or rear side/end)
The word зад can be translated as: ass, rear, backside
I looked in the rear view mirror.He is hiding in the rear of the house.Stop staring at my rear.
Assuming you mean a Mauser 24/47, use the sight as you would any open rifle sight. The slider on the rear sight adjusts for range- marked in meters.
ask your question at: gunboards.com (wanted section)
Your eye is the rear sight.
The "P" designates peep rear sight & ramp front sight, not sure of the "G" designation.
Italian rifles were made in 3 calibers. 6.5 Italian, 7.35 & rarely 7.92 X57 commonly refered to as 8mm Mauser. If it is in a caliber other than 6.5 it usually is marked on the rear sight.
Yes, a front and a rear sight.
where can I buy a new rear sight for a spesco 38 special
I believe the serial number is behind or to the rear of the rear sight. you should be able to see serial number without removing sight
I'm assuming you mean the iron sights mounted to the barrel of the rifle? Elevation is adjusted by sliding the sight elevator front to back on the rear sight. Windage is adjusted by drifting the front sight left-to-right. If the gun is 'shooting to the left' tap the front sight slightly to the left. A very small movement will have a major change. You could also tap the rear sight slightly to the right to effect the same change. If the gun is 'shooting low', slide the sight elevator toward the rear to lift the rear sight leaf. Again, a very small change in adjustment will have a big impact downrange. sales@countrygunsmith.net
Tap it gently. that's all it takes! This is from the manual: Your rifle has been sighted-in and test-fired at the factory. Due to individual shooting characteristics, however, sighting should be range verified. 1.) Vertical Correction (Elevation) To raise the point of impact, raise the rear sight, by moving the sight elevator rearward. To lower the point of impact, lower the rear sight, by moving the sight elevator forward. The sight can be raised and lowered by moving the stepped elevator forward and back with your thumb. To move the point of impact to the left, tap the rear sight base to the left. To move the point of impact to the right, tap the rear sight base to the right. Windage adjustments to the rear sight can be made by gently tapping the dovetail portion of the rear sight in the desired direction.
adjust rear sight up for distance
A backsight is the rear sight of a firearm.