Want this question answered?
Surface tension.
Technically, No. Water in a glass (or other vessel) has a curved surface known as a meniscus. A large body of water (like an ocean) actually follows the curve of the earth. So the surface of the water is a curve or section of a sphere.
Any, depending on the volume of water spilt and the area of the flat surface. The specific height is also constrained by the surface tension of the water, the atmospheric pressure above it, and the gravity below it.
They believe that it is from water flow.
The water is pumped upwards by the atmospheric pressure acting on the surface of the water in the well. That is only strong enough to support a column of water that is 10m tall.The water is pumped upwards by the atmospheric pressure acting on the surface of the water in the well. That is only strong enough to support a column of water that is 10m tall.The water is pumped upwards by the atmospheric pressure acting on the surface of the water in the well. That is only strong enough to support a column of water that is 10m tall.The water is pumped upwards by the atmospheric pressure acting on the surface of the water in the well. That is only strong enough to support a column of water that is 10m tall.
Evaporation occur at the surface of water.
There is no set rule for the placement of a dinner plate, but a good host will set a salad or bread/roll plate to the top left and a soup bowl and plate can be placed upon the top of the dinner plate if desired. A glass of water and/or wine can be placed at the top right.
Please mention the particular application of MS plate.....(sea water,DM water ,)
the surface water would lower and lower, and eventually dry up.
Yes, but the surface of water can also be inside of air bubbles, and so forth, too.
Drops of water at lower side of plate appear due to condensation.
The water surface able to be evaporated is greater.
Because if the plates are wet you will not get individual colonies, instead you will get a film of bacteria growing in the water film on the surface of the plate. This can ruin a selection for transformants as the antibiotic will not be present in the water film on the surface of the plate.
because of plate tech tonics and erosion takes hundreds of years to happen. it took tons of water and a couple hundred years for the grand canyon
it floats.They float at water surface.
High surface tension causes water to behave as if its surface had an elastic membrane, which was stretched. Due to water's high surface tension, effects like tears of wine and rain water beading on a leaf or grass happen.
die..and its body will float on the surface