it will explode
A fixture or device that holds a light in place by means of some sort of socket, that is connected to a power source.
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
Extra wires to a light fixture are dangerous. It can cause electrical shock when having contact to people therefore it must be guarded to avoid physical contact.
To control a light with a switch, the switch has to be connected in series with the light fixture.
If the ballast of the HPS fixture has a 120 volt tap then, yes it can be plugged into a 120 volt receptacle.
Beats me
A fixture is what the light bulb goes into.
The correct spelling for a fancy light fixture is "chandelier."
The light is wired the same as any voltage fixture. Bring the source voltage to the fixture and connect it to the two fixture wires. If you want to control the off-on of the fixture take the source voltage to a switch first and then out of the switch to the light fixture.
Take the nut off at the bottom of the light fixture by unscrewing it.
It Gets hot
Disconnect the fixture wires and remove the central mounting nut to release the dome from the light fixture in a ceiling fan.
It makes the motor run insufficiently.
If you install a bulb and it immediately fails with a flash then the fixture or more likely the supply voltage is a problem. This is a rare failure mode for the standard screw-in incandescent bulb. Essentially the only way it can happen is if a voltage in access of the rated voltage is applied to the bulb. It is more likely that the fixture shorts out and takes the bulb with it during the current surge. This can happen more easily than a constant over voltage condition, but after that the fixture is usually toast. If there is a ballast built in to the fixture, it can fail in a way that can eat light bulbs. One other failure mode that can reduce life of bulb is an enclosed fixture that overheats and causes the bulb to have a reduced life span.
Well mine the light starts to blink from red to green back and forth. This happens when i leave it on the charger and over use it. Idk about other phones.
It just holds the bulb, does not have a switch in the fixture.
A lock is a fixture, same as a light, sink, tub. A fitting is usually a part of a fixture, or a fixture is made up of fittings.