it truly depends on the device that is supplied and what you mean by " too much". Generally overvotage is bad and will shorten the components life, considering it was desined and built to work in a certain range. Severe over voltage will cause almost all electronic devices will burn though very quickly. A motor windings will burn out in short order or the insulation will punch through and cause a turn to turn short. Purely resistive load will over heat and fail very quickly
A regulator loses some voltage in regulating its output, known as the dropout voltage. So the input voltage must be at least the output volts plus the dropout volts. If the input voltage is too low, the output will drop out of regulation.
Overheating is a result of too much current flowing. AC motors are constant power devices, meaning they require the same amount of power to spin under a specific load. Power is equivalent to voltage times current. If voltage to a motor sags, the motor will attempt to make up the lack of voltage with an increase in current so the power stays the same. If voltage sags too much, the motor will overheat.
When an alternating voltage is applied to a purely resistive circuit, the resulting current is in phase with the voltage.
No...that's too much voltage, and 277v is normally three-phase power.
After breakdown voltage is reached in a zener diode the current increases drastically.
When it says the map sensor voltage is too high, this means that too much voltage is reaching the sensor. This can be a result of a failed component or a shorted wire coming into the sensor.
If the vswr (Voltage Standing Wave Ration) is high than call drop chance increase.
A voltage regulator is just as it says. It regulates the voltage that the alternator in your vehicle puts out. Too much voltage and you'll overamp your wiring, and too little can cause parts not to function properly.
A voltage regulator is just as it says. It regulates the voltage that the alternator in your vehicle puts out. Too much voltage and you'll overamp your wiring, and too little can cause parts not to function properly.
Have the alterntor and voltage regulator checked.
Not much, but it depends on the load and the cooling.
excessive voltage usually. can be caused by a voltage spike at the alternator, a computer sending too much voltage, or poor wiring
In order to double the voltage across a capacitor, you need to stuff twice as much charge into it.
If the load current is too high, the power lost in the transformer windings will be too high and it will overheat. If the voltage is excessive, the power lost in eddy currents in the magnetic core will be too high and it will overheat.
If there is to much rain, then we will have floods.
if there too little water animal die crops are not growing and if their is too much water flood came
you can die