Red is the alternate hot leg in a 2 way switch circuit
Remove the light sensor and place a switch between the red and black wires. The black wire is one leg of the "hot" pair and the load is connected to the red wire. This will now switch the black hot through the red wire that goes to the load.
The term switch leg really means switched leg. It is the wire that comes off of the bottom terminal of a switch and when the switch is turned on becomes hot. This is the leg that turns the load off and on.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
There is not enough information to answer this question.
Connect the black wire to the incoming hot wire and the red wire to the out going load.
the thermostat has a black(line) wire to it, and a red wire going to it. the red wire then connects to the neutral wire. the black and red are like a leg switch.
Remove the light sensor and place a switch between the red and black wires. The black wire is one leg of the "hot" pair and the load is connected to the red wire. This will now switch the black hot through the red wire that goes to the load.
The term switch leg really means switched leg. It is the wire that comes off of the bottom terminal of a switch and when the switch is turned on becomes hot. This is the leg that turns the load off and on.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
In residential wiring, if it is used as a switch leg or in 3 wire 240 volt circuits.
If you have one wire into your switch box for your light. this is called a switch leg, the dimmer should be wired across the black and white wire wires.
There is insufficient information to answer your question. A red wire can be used as a switch leg, it could also be the other half of a 240 V circuit or even the feed for a fan circuit, just to name a few possibilities.
There is not enough information to answer this question.
Nothing.
Connect the black wire to the incoming hot wire and the red wire to the out going load.
Yes
Red