That is 10 amp wire.
600 watts
Yes, you splice a small length of 16 gauge wire to 18 gauge wire for a repair.
According to NEC, it's max rating in free air is 18 amps.
The only thing you need to know in order to size your wire is the "5.1 amp" amount.Figure on the motor drawing double on startup, so say, 10 amps, or so.18 gauge wire would pack your 5.1 amps just fine, but it is a little flimsy . . . I would use 16 gauge, instead.Of course, the insulation on the wire you select should be rated for 600 volts or more.
That is 10 amp wire.
600 watts
12 ga, 20 amp. 14 ga, 15 amp. 16 ga, 10 amp.
16-gauge wire has a diameter of 0.05082 inches.
Yes, you splice a small length of 16 gauge wire to 18 gauge wire for a repair.
Sorry, there is no such wire size as "30 gauge" in the AWG (American Wire Gauge) system. For the ampacity rating of all standard conductor sizes, go to Table 310-16 of the National Electric Code. If you mean what wire size will carry 30 amps then a #10 copper wire insulation rating of 90 degree C is rated at 30 amps.
The gauge of wire that is 12 volt is 18, 14, and 16.
According to NEC, it's max rating in free air is 18 amps.
The only thing you need to know in order to size your wire is the "5.1 amp" amount.Figure on the motor drawing double on startup, so say, 10 amps, or so.18 gauge wire would pack your 5.1 amps just fine, but it is a little flimsy . . . I would use 16 gauge, instead.Of course, the insulation on the wire you select should be rated for 600 volts or more.
15 and 20 amps for receptacles and lights, and anywhere from 20 to 60 amps for dedicated loads such as water heaters and air conditioning. The fuse size MUST be matched to the load and wire size, you cannot just arbitrarily pick one!
16 gauge is rated at 13 amps, but I would use 14 gauge which is rated at 15 amps just to be safe.
its casing will dry out, crack and catch fire, or it will crack off and cause arking, which can cause a fire... ultimately, check the gauge size of the circuit and make sure it corresponds to the proper amperage of breaker, if this is all good, you need a bigger cord(the gauge size must be sufficient for the intended tool/device.. a drill that has a 16 amp rating needs a 12 gauge cord whereas a 12 amp drill needs only a 14 gauge cord.