Left to right or right to left.
One way is to use a protractor. There are others
With a straight edge and a protractor is the simplest way.
Place the center of the protractor on the vertex of the angle. Align the base of the protractor with one side of the angle. Read the measure where the other side of the angle intersects with the protractor scale. Note the measure in degrees.
There isn't a formula for determining the degrees of a simple acute angle. The only way is with a protractor or estimate.
you can only draw an reflex angle if you have a circular protractorthere is also a way with a normal protractor you can rotate your protractor and there you can now make ur Reflex angleRememberyou should minus 1 degree
One way is to use a protractor. There are others
With a straight edge and a protractor is the simplest way.
Place the center of the protractor on the vertex of the angle. Align the base of the protractor with one side of the angle. Read the measure where the other side of the angle intersects with the protractor scale. Note the measure in degrees.
The best and most obvious way is to use a protractor. Other than that, there is no obvious and easy way.
There isn't a formula for determining the degrees of a simple acute angle. The only way is with a protractor or estimate.
you can only draw an reflex angle if you have a circular protractorthere is also a way with a normal protractor you can rotate your protractor and there you can now make ur Reflex angleRememberyou should minus 1 degree
A "protractor" is a device that can be used to draw angles of a specified size, or measure the size of unknown angles, in the same way that a "ruler" is used to do the same thing with lines.
A right angle sits at 90o, which is right in the middle. Anything less than 90o, or to the left on the protractor are acute angles. Anything to the right, or bigger than 90o, would be considered an obtuse angle. A good way to remember this is that an acute angle is "a cute little angle."
You should use a protractor, a protractor is the best way to identify an angle or line. They can often be bought at hardware or craft stores. The measurement units are revolutions, degrees, and radians.
You should use a protractor, a protractor is the best way to identify an angle or line. They can often be bought at hardware or craft stores. The measurement units are revolutions, degrees, and radians.
A protractor is a tool that may be used to measure an angle. The measure of the angle exists irrespective of the tool that is used to measure it. In the same way that you have a height and your height is a [mainly] fixed amount and whether it is measured with a rule or a tape measure or a laser range finder does not affect your height!
There are many ways to measure a contact angle, but the simplest way is to use a goniometer. The image of the droplet is taken with a high resolution camera; the angle can then be measured using a protractor.