It depends on the cable. 0 to 5000 volts the minimum bending radius is 6 x diameter of the cable. Above 5000 volts the minimum bending radius is 8 x the diameter of the cable.
It is twice its radius or its circumference/pi
For Unshielded cables, it will 8 multiplies cable diameter and for shielded cables, it is 12 multiplies the cable diameter. However, the smaller the bend radius, the greater is the material flexibility.RegardsKelechi
4 times the diameter of the cable
Yes.
It depends on the cable. 0 to 5000 volts the minimum bending radius is 6 x diameter of the cable. Above 5000 volts the minimum bending radius is 8 x the diameter of the cable.
15 D
I believe you want to know the MINIMUM bending radius of sheet metal. The maximum bend would be 180 degrees.
Minimum Bend RadiusCable TypeFixedInstallationModerateFlexCableTracksUnshieldedCables4 x CableDiameter6 x CableDiameter8 x CableDiameterShielded Cable4 x CableDiameter8 x CableDiameter12 x CableDiameterExample:A 19/C 18 AWG flex cable - .565" diameter - has a minimum bend radius of 4.5 (.565" x 8 = 4.5).
Can you mix condenser mics with directional mics using phantom power?
cable radius
The radius of the curve of the inner edge of the bends shall be at least 6 times the external diameter for armoured cable.
Every bending mechanism gets governed by the simple bending equation M/I=F/y=E/R
Sharp bending, cable pinch, spyware, worm virus, sending or receiving of large email, streaming.
Typically, wires have a bend radius of 10 times the diameter of the wire. Measuring the inside. This is basically to prevent injury or changes in impedance at the bend. Also note that the tighter the bend can damage the insulation in coaxial or triaxial cables and cause lower dielectric strength between layers. Best to install cables where ripples don't form on the surface and moderate force is recommended. MIL-W-5088 has more information.
6x od
It is twice its radius or its circumference/pi