a clock signal is a particular type of signal that oscillates between a high and a low state.The term is here used for "transmitted energy that can carry information".
that depends on the microcontroller. check the datasheet.
In PIC Microcontroller , During the Fatching of instruction no. 1it needs of one clock cycle, then after for the exicution of instruction no. 1 it reqires one extra clock cycle , but at the same time it fatches inst. no. 2 . Similarly, during the execution time of inst. no. 2 , it fatches inst. no. 3 and so on.In other words we can say that, PIC Microcontroller requires 2 clock cycle at starting the after it requires only one clock pulse. In this way we can say that instruction pipelining is done in PIC microcontroller.
it is a programmable logic device which has a inbuilt memory, clock etc and is required to perform a specific task.
my balls
Oscillators are connected externally with the microcontroller to provide high frequency signal to the oscillator circuit in the microcontroller. The oscillator circuit provides the clock signal to the micro controller. Usually "PIEZO CRYSTAL OSCILLATORS" are used in micro controllers.
That depends on the specific microcontroller.
Fully Static Operation in any microcontroller is, u can hold ur controller by stopping the clock and It doesnt affects ur stored content in registers or RAM.Again the controller can be resumed by allowing the clock.this static operation is possible only as long as controller is provided with the power.
x
The PIC is a specific architecture of microcontroller.
The voltage of the 8031 microcontroller is 2.7V to 5.5V.
The 8051 Microcontroller is a microcontroller ("chip") developed by Intel in 1980.
PIC Microcontroller which means Peripheral Interface Controller. PIC Microcontroller is originally developed by General Instrument's Microelectronics Division.