Be notified when an answer is posted
The "pick up" of a relay is a setting at which the relay will begin to operate. Such as an overcurrent relay - if the pickup is set to 5A, when 5A is flowing through the relay, the relay will operate.
A definite time over-current relay operates like an instantaneous over-current relay coupled with a timer. Once current reaches the pick-up value, it initiates the timing circuit. As long as current stays above this pick-up value, the timer will continue to time. Once the definite time setting is reached, the relay gives trip signal to the circuit breaker.
you take a tooth-pick and find the reset button and when you find it use the tooth-pick to reset it
There is no such thing as resetting the pick-up module
You full reset the Micromax Q7 mobile by turning the phone on and then going to options. From there, pick phone settings and then pick phone. There should be a list of options, choose the one titled 'reset'. This should reset the mobile device.
In the under hood relay/fuse center.
the blinker relay is behind the glove box
The solution here ended up being a procedure. Disconnect the battery. Disconnect the control module. Wait. reconnect in reverse order. There should now be 12V on the fuel pump relay with the ignition key on. Do this before buying an unneccesary fuel pump.
The starter relay is located on the battery side of the engine compartment on a 2002 F150 pick up truck. It is on the firewall close to the battery.
inside starter.
No.
If you are talking about a fuel pump reset button, it doesn't have one.