This site might be able to help:* http://whatsitworthtoyou.com/
It depends what you are trying to accomplish, but sometimes you pick a value of x. For example, if you want to graph a function, one approach is to pick several different values of x, solve the equation for each value, and write that as a point on the graph. It may then be possible to connect the points into some kind of coherent shape (although this depends upon the particular function - some are easier to graph than others).
The three integers are 27, 28 and 29. Pick your own x...
20,000 --------------------------------- You need to specify a value such as ones, tens, hundreds, thousands, or ten-thousands. To get the greatest value by rounding you would do all of these, compare them and pick the greatest. 22,000 is greater than 20,000 and you get this by rounding to the thousands place.
They are the set of points that satisfy the equation Y = 4X + 2. So pick any value for X. Multiply it by 4, add 2 and you have the corresponding value of Y. That point (X, Y) is one of the points on the line. Pick another X and calculate the corresponding Y. And so on.
A definite time over-current relay operates like an instantaneous over-current relay coupled with a timer. Once current reaches the pick-up value, it initiates the timing circuit. As long as current stays above this pick-up value, the timer will continue to time. Once the definite time setting is reached, the relay gives trip signal to the circuit breaker.
The "pick up" of a relay is a setting at which the relay will begin to operate. Such as an overcurrent relay - if the pickup is set to 5A, when 5A is flowing through the relay, the relay will operate.
you take a tooth-pick and find the reset button and when you find it use the tooth-pick to reset it
There is no such thing as resetting the pick-up module
The solution here ended up being a procedure. Disconnect the battery. Disconnect the control module. Wait. reconnect in reverse order. There should now be 12V on the fuel pump relay with the ignition key on. Do this before buying an unneccesary fuel pump.
You full reset the Micromax Q7 mobile by turning the phone on and then going to options. From there, pick phone settings and then pick phone. There should be a list of options, choose the one titled 'reset'. This should reset the mobile device.
In the under hood relay/fuse center.
the blinker relay is behind the glove box
The starter relay is located on the battery side of the engine compartment on a 2002 F150 pick up truck. It is on the firewall close to the battery.
inside starter.
Pick up current is the minimum current required to initiate the operation of a relay and close its contacts. It is the threshold current level at which the relay switches from its deactivated state to its activated state.
GM vehicles do not use inertia/reset switches.