0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the difference between relay and fuse?
A relay is a switch; it is not usually meant to open under fault conditions (high current), and would likely fail if done so. A fuse is a fault protection device. If a short circuit develops, large currents will flow, and the fuse link will melt, causing the circuit to open. There are also protective relays, which are devices that sense fault, or other undesireable conditions, and are used to send trip commands to breakers.
Suppose an electric motor with a controller is not working. What is the sequence of testing you will do in your troubleshooting?
1st check the power supply switch whether on or off then Check the all wiring connections may be wire disconnected or there is any loose connection(OFF the switch). smell the component whether it is heated or not and touch to experiance the heat(OFF the switch). replace the controller/motor with new one to detect fault present in which part.
What is the difference between an air break switch and an isolator?
An air-break link (ABL) switch is designed to interrupt normal load currents (but not fault currents). In order to do so, they usually incorporate some form of very simple arc-extinguishing feature.An isolator switch, on the other hand, is not designed to interrupt current, but to isolate equipment after that equipment has been disconnected (e.g. by opening a circuit breaker).
What is the antonym for fault?
A fault is a flaw or a disadvantage. An antonym for fault would be virtue, advantage, asset, merit, or strength.
What are symmetrical and unsymmetrical faults?
the fault in electrical transmission line which give rise to symmetrical fault current is called symmetric fault. e.g; L-L-L-G fault. the fault in transmission line which give rise to unsymmetrical fault current is called unsymmetrical fault.e.g; L-L , L-L-G , L-G fault to solve the unsymmetrical fault, the fault current can be represented by sum of the sequences--zero phase sequence , +ve phase sequence , -ve phase sequence. where L:line G:ground
What is a no fault switch?
There is no electrical terminology that refers to a "no fault switch".
What is a switch fault?
There is no electrical terminology that refers to a "no fault switch".
How do you wire a ground fault switch?
To replace the wire ground fault switch, you need to switch off electric power from the source. After switching it off you can use the screwdriver to open screw and remove the faulty switch and replace it with a good one. <<>> There is no such a device as a ground fault switch. There is a ground fault breaker and a ground fault receptacle.
What is a NO switch?
There is no electrical terminology that refers to a "no fault switch".
What could cause a single pole switch to make noise?
That indicates a fault and the switch needs replacing.
Is there a fuse for the hazard warning light?
no fuse the switch is the common fault
How to fix lid switch on kitchen-aide washer?
If you are sure the lid safety switch is at fault do not bother with it, they are cheaper and easier to replace
Why does my dims work but not brights?
First, be sure the high beam bulbs and fuses are good. From there I would suspect the high/low beam switch is bad or out of adjustment. Really need the year, make and model to add further possibilities.
Will my Ford fiesta engine light automatically switch off when problem resolved?
Once the problem has been resolved switch off the ignition, leave it a few seconds, then switch on again and the engine fault light should be off. If it remains on then there is a possibility you may have more than one fault.
Indicators on Audi a3 do not work but hazard warning indicators do?
It could be the indercator switch i just had the same fault on a Hyundai and it was the indercator switch
Dodge Durango fault code P1734 means what?
2 c pressure switch
What does fault code 522780-3 mean on a Hyster Forklift?
check your minitrol switch's
