If: A=Horizontal distance betwen ends (at same height) B=Depth of catenary C=radius of curvature at lowest point L=length along catenary M=Mass per unit length Tm=Tension at ends of catenary To=Tension at lowest point. (Also horizontal component of tension at any point) Then: C=To/M, and B=C(cosh(A/2C)-1)
-The tension of the cable (the tighter, the less sag, but this can cause other problems if too tight) -The temperature outside (the higher the temperature, the more it will sag) -The amount of current flowing through the cable (the more current, the hotter the conductor will get = more sag) -The type of cable (aluminimum will sag more than copper; ACSR will sag less than straight aluminimum).
i know someones going to be on this sooooooooo....... they sag because the hydro workers know, from the heat the cbles will sag during the summer, so they start the sag so they cant sag anymore
The plural of sag is sags, not sag's! Sag is caused by the weight of the conductor between its supports, and is (a) unavoidable and (b) necessary to allow for the conductor's expansion and contraction during variations in temperature. When surveyors design a power line, the amount of necessary sag is calculated and built into the design, while ensuring that the clearance between the conductor and the ground remains within safe limits.
Tacoma narrow bridge.
i think sag compensation springs are used in dead end termination of quadra conductor bus where jack bus is passing below bus & required clearence if we are not getting betn two buses their these sag compensation springs are used to bring conductor under tension .
Catenary
The general formula of a catenary is y = a*cosh(x/a) = a/2*(ex/a + e-x/a) cosh is the hyperbolic cosine function
Catenary taping is a technique commonly used by athletes to provide support and stability to muscles and joints. It involves applying specialized elastic tape in specific patterns along muscles and tendons to help reduce pain, improve performance, and prevent injuries. The tape is designed to mimic the elasticity and thickness of human skin, allowing for a wide range of motion while providing support.
generally more than three shafts contact by coupling together in steam turbine. the shaft is heavry and will be sag. in order to reduce the bend force on coupling and bend force on bearing, the engienering calclated the shaft and simulated when its in operation condition. so, the catenary curve and bearing elevation data have been provided for steam turbine installation.
sag hight of lense 1.53 ? radius of lense index 1.498
5
sag
A equation is santa clause
sphere
The Catenary and Parabola are different curves that look similar; they are both "U" shaped and symmetrical, increasing infinitely on both sides to a minimum.
A catenary is the curve formed by slack wire - telephone cables are a good example. So a catenary tow is one where, simply put, the towline is attached to shackles of anchor cable in order to ensure that a belly of towline (providing spring) hangs between the two ships.
SAG