answersLogoWhite

0

What is the angle in 6 blade fan?

User Avatar

Anonymous

14y ago
Updated: 8/19/2019

six blades of a fan divide 360 degrees into six segments. each angular segment therefore is of 60 degrees each.

So angle between blades of a 6 blade fan is 60 degrees.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the wheel and axle on an electric fan?

The 'wheel' is the fan blades and the axle runs directly at right angle to the blade, through the centre of the motor.


What puts out more air- a two blade fan or a four blade fan?

A four-blade fan typically moves more air than a two-blade fan because it has more surface area to push the air. This allows the four-blade fan to generate more airflow with each rotation compared to a two-blade fan.


How do you remove the fan blade from the fan motor on a 1994 Plymouth Acclaim 30litre 6 cyl there are no screws and the blade will not slip through the piece that the clip goes on should you File it?

File the outside edges of the rod that slips through the fan blade lightly, it went in, it should then slip out.


What type of fan blade do you need for a serpentine belt on zz4 motor?

a reverse fan blade and fan clutch


Best blade angle?

the best angle is "45 degree" because the air speed coming out of the fan is giving by this equation V=v.tanθ were : V: air speed,,, v: is the blades speed and we got the maximum of the speed by making the angle 45


What is turbine blade angel?

turbine blade angle is that angle with which,a high presseure & high temprature steam is made to empenge on it.


How do you remove a fan blade from a 1998 Ford Explorer?

how do you remove a fan blade from a 1998 ford explorer


Why does my jigsaw cut at an angle?

Your jigsaw may be cutting at an angle due to a misaligned blade or a worn-out blade. Check the blade alignment and condition to ensure straight cuts.


How do I perform an AC fan blade replacement?

To perform an AC fan blade replacement, first turn off the power to the AC unit. Remove the outer cover of the unit to access the fan blade. Use a wrench to loosen the nut holding the fan blade in place. Carefully remove the old fan blade and replace it with the new one, making sure it is securely attached. Tighten the nut to secure the new fan blade in place. Finally, replace the outer cover and turn the power back on to test the new fan blade.


How Remove fan blade from 1999 Dodge 3.9 magnum?

The wench will be used to remove the clutch fan nut. Remove the nuts holding the fan then remove the fan blade.


How do you calculate area wiped by windscreen wiper?

Measure pivot point to bottom of blade and pivot point to blade tip, measure angle from extreme left to extreme right of pivot point in degrees. If not possible measure the distance from top left point of blade on windscreen to top right point on windscreen.Transfer measurements to large piece of paper and draw a fan shape to represent the readings taken. Large circle area is pivot to blade tip, squared x 3.142 small circle area is pivot to blade bottom ,squared x3.142 Subtract small circle area from large circle area. This is a full 360 degree blade sweep area. Now take 360 degrees and divide by the angle of sweep, for example if sweep angle is 60 degrees:- 360/60 = 6 Divide answer by 6 to get area cleaned by wiper. Multiply by 2 for both blades in this example.


How do you take fan blade off of a Emerson electric co fan?

To remove the fan blade from an Emerson electric fan, locate the screw or bolt at the center of the blade and use a screwdriver or wrench to loosen and remove it. Be sure to support the blade while removing the screw to prevent it from falling off. Once the screw is removed, gently pull the blade away from the motor to detach it.