Using Ohm's Law. It is 2.5 volts divided by 5.0 ohms which is 0.5 Amperes.
V = IR
V = 5A * 25Ω(ohms)
V = 125V
We've made some capitalization changes to your answer. Please review it below.
Stop making changes. You're messing it up.
No current flows when the the voltage is zero.
22ma. E=R/I
Resistance (Ohms) = Potential Difference (Volts) / Current (Amps) So, 12/0.25 = 48 Ohms.
Use Ohm's Law, i.e., V=IR here, V=voltage I=current R=resistance
current flows as a result of potential difference i.e. in a circuit if there is no voltage difference between two points, no current can flow between those two points. So voltage has to be produced first.
The potential difference accross the resistor changes mainly due to gradual increase accumulation of electrons in the lower potential region which will in turn affect the potential gradient as the current flows through the resistor
Potential Difference across a resistor is given by, Potential Difference = Resistance * Current = 1500 * 0.075 = 112.5 Volts
The difference between a Transistor and a Resistor is that a transistor is designed to amplify the electrical current, whereas a Resistor is designed to reduce the electrical current.
Your question reveals fundamental misunderstandings about the nature of electricity.'Voltage' is simply another word for 'potential difference', and a potential difference appears across opposite ends of the resistor; it doesn't 'travel through' that resistor! Current, on the other hand, DOES 'travel through' the resistor and is caused by the potential difference across the resistor.Resistance is the ratio of potential difference to current. So if the resistance remians unchanged when the current through it doubles, then it has happened because the potential difference has doubled.
Work it out yourself. PD=P/I, Where PD=Potential Difference, P=Power & I=Current
Potential difference equals current multiplied by resistance or E = IR therefore the answer to your question is 25 volts
No current flows when the the voltage is zero.
22ma. E=R/I
Resistance (Ohms) = Potential Difference (Volts) / Current (Amps) So, 12/0.25 = 48 Ohms.
First of all, current goes straight through the resistor, not across it.If the potential difference between the ends of the resistor is 20 volts,and its resistance is 10,000 ohms, then the current through it isI = E/R = 20/10,000 = 0.002 ampere = 2 milliamperes
A possible/probable unit is Watts.
Charge is potential, current is flowing.