0
O buckshot is 0.32" (8.1mm) in diameter.
http://en.wikipedia.org/wiki/Shotgun_shell#Buckshot
9 of these pellets weighs an ounce, so there are 144 per pound. A pound is 7000 grains, which means a single O buckshot pellet weighs 48.6 grains. This is just more than half what a typical pistol bullet of that caliber weighs, and less than a third of what a typical 8mm rifle bullet of that same caliber weighs.
Add your answer:
Earn +20 pts
What is symbol for O with line through it?
The diameter.
What you get when you divide the diameter of a jack-o'-lanterns by its circumference?
3.14159
What do you get when you divide the circumference of a jack-o'-lanterns by its diameter?
Pi.
What does o d stand for on PVC pipes?
Outside diameter
What is the diameter of a pin head?
1.5 t o 2mm
What do you get when you divide the circumference of a jack-o'-lantern by its diameter?
When you divide the circumference of a jack-o-lantern by its diameter you get Pumpkin Pi.
What is a thread-o-let?
A thread-o-let is a female by weld connection. It is commonly seen on large diameter pipes where a valve or other connection (typically much smaller in diameter) is made.
What is formula for radius o a circle?
radius = 1/2 diameter
What is the radius of a circle with a diameter o f 8 inches?
4
What you mean by nominal diameter of an O ring?
O-Rings have 2 diameters. The first is the diameter of the rubber from which the ring is made, the second is the diameter that the ring forms. "Nominal" in the case of the former reflects the fact that the ring may not have the exact same diameter all the way around. This is due to the imperfect nature of its manufacture. "Nominal" when applied to the latter means that because an O-ring is inherantly flexible, its outside diameter is hard to measure exactly. The word "Nominal" simply means average, or most easily measured. Put a steel rule across an O-Ring in 1,000 different directions and you will always get a slightly different reading.
The blue segment below is a radius of O. What is the length of the diameter of the circle?
the andser is 9
A hollow shaft has an outside diameter of 35mm and an inside diameter o?
Any measurement smaller than 35mm. That measurement would depend on the thickness of the material making the tube
