Full load amps is the amperage at which the motor was designed to work at to achieve its rated horsepower. Service factor amps is the amount of a periodic overload at which a motor can operate without overload or damage. Continuous operation within the service factor amps will shorten the insulation and motor bearing life of the motor as the motor will be operating at a higher temperature than it was designed to.
Both are meaning the same definition. simply you put factor beyond the safety.
They store charge between their plates in an electric field
Fill factor is the ratio (or the difference) between the actual output of a solar cell or panel, and its theoretical output (which can be about 30%higher).
Power factor does not go above 1. It is the cosine of the phase angle between voltage and current and, as such, can range between +1 and -1, although it should be understood that a negative power factor is mathematically equivalent to a generator - when looking at the load as if it is a motor - or vice versa. Unity power factor is applicable for a resistive load. A typical power factor for a big motor is about 0.92. A theoretical power factor of zero, corresponding to a phase angle of 90 degrees, would mean that the load is purely inductive or capacitive, and that the power supply and conductors are also ideal or theoretical.
The power factor is a measure of the phase difference. If they are exactly in phase the PF = 1. If they are 180 degrees out of phase PF = 0.
There is no difference between "factor of safety" and "safety factor." They are two ways of saying the same thing.
define motor service factor? define motor service factor?
The electric force between two charged particles is inversely proportional to the square distance between them.Accordingly, it is reduced by a factor of 9
a factor is what you multiply by a multiple is the answer
A factor of 1000
Biotic = Living Abiotic = Non-Living there is a lot of difference between a thing that is living and a thing that is non living.
The lowest factor is 2 and the highest is 11 so the difference would be 9.
If that's greatest common factor and greatest common divisor, there is no difference between them.
The difference between a single-factor and multi-factor region is that a single factor region is based on a single physical feature and characteristic. A multifactor regions is based on multiple physical features and characteristics.
It is increased by a factor of 2
The GCF is the largest of the common factors.
A factor of an experiment is a controlled independent variable; a variable whose the differences between means for different levels of one factor.