dont know -------------------------------- EDIT: 2 Channel if really what its sounds like, 2 channels which means you have a Left + Right basically. 4 Channels is for 4 channels which like in a car would be Front Left + Right and Rear Left + Right. Reminder!!! Check RMS NOT max Power!!! -TheRamMan-
Yes, the only difference is one will charge twice as fast as the other! -Dale
What is the difference between 2-pentanol from 3-pentanol?
Yes it can affect only one. But the number it can affect depends on how many outputs on the mixer. Most mixers have stereo(LR,2 channel) or mono outputs. In depth:Also, there can be subgroup, auxiliary, and matrix mixes.
yes, you can, either via a Y-cable to the sub output, or via a pre-amp, or hook them up parallel to a mono amp or if you have a 2 channel amp then just hook them up regurally but if you have a mono amp then...have two positive and two negative wires coming out of the amp then hook 1 negative wire up to the negative spot on a speaker..then do the same with the other..then do the same with the positive
There should be no difference between two 20-amp fuses. A 20-amp fuse is designed to handle up to 20 amps of current before blowing, so as long as both fuses are properly rated for 20 amps, they should have the same functionality and performance. However, it's important to consider the quality and reliability of the manufacturer when choosing fuses to ensure they meet safety standards.
Yes you can burn a channel on an amp. Which is do to a overload. Like a 2 ohm load on an amp that is not 2 ohm stable. Will burn out a channel or both channels.
Monoblock amp? No. Only 1 channel which is good for one speaker, or one sub. What you need is either a 2 channel amp or a bridgeable 4 channel amp, which would be overkill anyway. If the amp you have is 2 channel, it would be ideal.
Monoblock amp? No. Only 1 channel which is good for one speaker, or one sub. What you need is either a 2 channel amp or a bridgeable 4 channel amp, which would be overkill anyway. If the amp you have is 2 channel, it would be ideal.
If you bridge a 2 channel 4 channel ect. you are taking the power from both channels as if it was a single channel amp.
No that would be a 2 channel amp. 1 speaker per channel. 2 speakers= 2 channels 4 speakers= 4 channels
2 Amp
jl audio 500/1
a channel refers to the speakers or subs. for example a 2 channel amp can power 2 subs or speakers. a 4 channel will power 4.
Use 1 channel for fronts & the other channel for the rears.
Yup
A 2 channel 900w per channel amp or less will run it, or a 1800w one channel amp etc.. Keep in mind the ohms need to match up too
well if its a 2 channel then 1 pair of subs like if it has only one red and one white connecters then only one pair of subs then if it has 2 of each then 2 pairs of subs that's called a 4 channel amp seacrh in Google 4 channel amp and 2 channel amp you'll see what am talking about see look http://akamaipix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/4DVC_4-ohm_4ch.jpg