The Full load current of that amp is approx. 17A, but you base you fuse size between the Full load current of your load and the current carrying capacity of the supply cable, if the size or the CCC of the cable is unknown, I would recommend sticking as close to the FLC as possible
assuming this is a 12 volt system....45 amps.
No, it is not alright to replace a 180 watt DLP TV bulb with a 200 watt bulb. You should only use the OEM rated size/wattage for your TV.
As much as someone is willing to psy
Yes it should be all right. Ratings for amp/speakers are approximate but as a rule it is preferable for the speaker to be rated higher than the amp.
Not unless the device is running at less than 333 volts.
assuming this is a 12 volt system....45 amps.
No, it is not alright to replace a 180 watt DLP TV bulb with a 200 watt bulb. You should only use the OEM rated size/wattage for your TV.
200 Watt Panel
The equation that you need to use is I = W/E. Amps = Watts/Volts. As you can see there is no voltage stated but when you obtain the voltage value use it in the equation.
The formula you are looking for is Amps = Watts divided by Volts. Once you find the amperage you can decide as to the size of a fuse you should use. Remember that fusing protects the conductors of the circuit and not the load of the circuit. A #14 wire is rated at 15 amps and can legally be loaded only to 12 amps.
it is 200 ft.
About 200 Dollars
Mulb ;)
Yes
bright light
Bright Light.
he was about 200 pounds and 5 feet and 7 inches