0
What is the maxium length of 5 inch greenfield used as a fixture whip without support?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How To FIND tHE perimeter without the length?
You cannot. You must know, or be able to derive, the length.
What length should be used for the 36 ft support?
i am going to say yards
How do you find the length of a cube without a calculator?
Use a ruler
A rectangle has a permeter of 60 cm. its length is 5 times greater than its with. what is its length?
25cm - without using a calculator !
XY written without a bar above it stands for a segment's?
length
What is usually regarded as the absolute maximum length a driveshaft should be without adding a center support bearing?
70 inches is usually regarded as the absolute maximum length a driveshaft should be without adding a center support bearing
How many fixtures can1.5 inch pipe vent?
That would depend on the fixture units each fixture has and the developed length of the vent piping
How do you plan out fixture drain venting?
By developed length and the amount of fixture units attached (1 FU =7.48 gallons) 1 cu ft
What size pipes are needed for vent pipes?
It depends on the developed length and fixture units.
How do you calulate the length of galvanized pipe?
By developed length of piping and fittings for venting and fixture units connected to it for water supply or drainage
How do you determine if the drain size is 4 or 3?
By the fixture units connected and the developed length of piping and fitting
How do you cap a garbage disposal that you have disconnected a dishwasher from?
Fit a short length of capped hose to the disoposal fixture.
What is the unsupported length of the column?
Length over which the column has no support is taken as unsupported length of the column
How far can the vent for the tub be away from the main sewer vent?
Up to 20,000 feet the fixture units and developed length are not exceeded.the key is to make sure the vent (even over 20,000 lineal feet) is pitched UP from the fixture being served so any condensation will flow back to the drain being servedEven with a very long run (20,000 PLUS) there should be no problems associated as long as the fixture units are below max allowed for the developed length of piping and fitting losses
What is the max length of cantilever beam?
1.50 meter from the support is the max. safe length cantilever beam
What is the max length of RC cantilever beams?
1.50 meter from the support is the max. safe length cantilever beam
How can find the length of a string in java without using fun?
Use length() method. Example: "java".length();
