answersLogoWhite

0

What else can I help you with?

Related Questions

How do you change a fraction into a hole number?

multiply by its reciprocol


What is a part of a hole?

A fraction is a part of a whole. So is a decimal. A negative number is not.


What is F8 in hole dimensions?

F8 refers to a specific hole dimension in engineering and manufacturing, particularly in the context of ISO hole tolerances. It indicates a hole diameter with a tolerance class that allows for a specific range of variations, ensuring that the hole fits the intended component or fastener properly. The "F" typically denotes a fine tolerance, while the number indicates the size or characteristics of the hole. This classification is crucial for precision in assembly and functionality.


What are the hole numbers on the top o each element represent?

The hole numbers on the top of each element represent the atomic number. This number indicates the number of protons in the nucleus of an atom of that element. It is a unique identifier for each element on the periodic table.


What is one hole as a fraction?

One hole can be represented as the fraction 1 whole, which is equivalent to the fraction 1/1. In fractional form, a whole is divided into one equal part, resulting in the numerator and denominator both being 1. This fraction represents the entirety of something without any parts missing.


What is 1 hole and a half in an improper fraction?

A hole is usually taken to be the absence of 1 so a hole and a half is a negative half or -1/2.


How do you multiply hole numbers and fractions?

You simply put the whole number over one making it a fraction then you flip the reciprocal and divide the two fractions insted of multiplying.


What are the parts of a cell and their uses?

Your face hole


What is the tolerance for a 150mm H7 hole?

The tolerance for a 150mm H7 hole is typically specified as +0.000 mm to +0.075 mm. This means that the hole's diameter can range from 150.000 mm to 150.075 mm, allowing for a precise fit while accommodating certain manufacturing variances. The "H7" designation indicates a specific level of fit, ensuring that the hole is neither too tight nor too loose for mating parts.


What fraction equals to one whole?

Every fraction that has the same value above and below the fraction line. 1/1, 2/2, 3/3, ...


How do you get a hole in one on hole number 6?

your lucky if you do


What parts of a snaping trutle can you eat?

the b hole