Want this question answered?
A pressure, its units are Force/Unit area
the area over which the force acts
1 m is not an area.
YES
Since Pressure is Force per Unit Area (P = F/A), there are intuitively two ways to increase pressure. You can either keep the area constant and increase the force being applied, or keep the force constant and decrease the area on which the force acts.
The area over which a force acts, is proportional to the pressure. When the area is large then, the pressure acted on it is also large, so the force is greater.
A pressure, its units are Force/Unit area
Pressure is a force defined as a push that acts over a certain area.
the area over which the force acts
1 m is not an area.
YES
If this is about a hydraulic system, same pressure acts through out the fluid. Take, A = cross sectional area (area normal to force) of piston 1 B = "" "" "" of piston 2 F2 = Force on 2nd piston So, pressure = 1000/A = F/B Therefore, F = (1000 X B/A ) N (The force depends on the area ratio)
Look in the book broseff.
No. The opposite is true.
Surface area of cell is divided volume of cell to get surface to volume ratio . If surface area is 8 cm2 and volume is 2 cm2 . The ratio would be 4:1 .
The area over which a force acts, is proportional to the pressure. When the area is large then, the pressure acted on it is also large, so the force is greater.
Force Divided by area