2400 watts.
No. But bear in mind that, in the case of a.c. circuits, 'total', means the phasor (vectorial) sum of the voltage drops, NOT the algebraic sum.
when the frequency is increased the total impedance of a series RC circuit is decrease.
The total power equals the sum of the individual powers because power is the rate at which energy is supplied. Whether you have a series or parallel circuit, the total power comes from the power source.
No, the total resistance increases.
P=VI, so P=24*2 = 48W.
The total allowable load in amps on a branch circuit by Code is 80 per cent of the circuit rating. Therefore, a 20 amp circuit shouldn't be loaded over 16 amps total.
no
No. But bear in mind that, in the case of a.c. circuits, 'total', means the phasor (vectorial) sum of the voltage drops, NOT the algebraic sum.
Yes as long as you stay within your local code. Usually a combination of lights and receptacles cannot exceed ten total. Do not wire any light to a circuit that requires a dedicated circuit, such as a refrigerator, dishwasher, etc.
A loss.
Net income
There's no maximum. However, if one were transporting bags full of rolled coins, the total weight per bag must not exceed the carry-on maximum.
In most countries it is against the law to exceed the speed limit. The total cost of the new airport will exceed 100 million dollars
The total resistance in a series circuit is determined by adding (summing) the individual resistances of each component in the circuit.
Current = (Voltage across the circuit) divided by (Total resistance of the circuit). The current is the same at every point in the series circuit.
multiply the total voltage in the circuit by the total amperage
You raise the total resistance by that amount if added in series to a circuit. If you add them in parallel to a circuit then that total resistance will be less than the total of the added circuit.